Pellington Design Confetti User guide

Mounting Instruction
Observe that depending on wall and load it could be necessary with more than two screws
to mount the shelf to the wall. Use screws adapted to the wall, typical dimension is 5x60mm.
One unit can bear max 24kg, the short shelves 3kg and the long 6kg.
Make sure you turned the backplate correctly before you start placing the bricks: see below.
The bricks also has an top/bottom side, makes sure to turn them right!
In the package, the bricks are
turned to fit a horizontal shelf
unit. If a vertical unit is prefered
please turn the bricks!
Large plug= Up
Vertical Unit
(upper left corner)
Horizontal Unit
(upper left corner)
Large holes= Up
Mounting Hole

Arrange the bricks. Leave two (or four)
bricks for easier mounting to the wall.
Lightly push the bricks in to the holes.
Use the foam in the package, cover
the bricks as protection and push firm
or gently “walk” them in to place!
Use the mounting holes and mount
the shelf on the wall with two (or four)
screws.
Mounting holes
Make sure it’s horizontal!

Push the remaining bricks in to place and
place the shelfs.
Sometimes some shelves can be a bit tight
to place: It’s easier to start with one of the
corners when pushing them in.
For changing the place of the bricks or
remaking the whole unit use the tool
included in the package.
If another tool is used (screwdriver or such)
use it in the large plug!
Tip!
Depending on screw, it’s possible to fine
tune the level with the screw head.