PEPE SUNSHINE User manual

SUNSHINE TABLE
ASSEMBLY GUIDE
1. Start by placing your tabletop upside down,
on an elevated surface around hip height for
ease (see picture 1).
2. Finger-tighten the bolts to the legs and
circular triple hinge, it is important to ensure
that the angled cuts at the boom of each leg
face in the circular direction (see picture 2).
3. When all three legs are aached, open them
up so the notched ends can reach and slot into
place snuggly on the edges of the table support
planks. Note: They do not go exactly in the
middle of the support planks that they reach
(see picture 3).
Picture 1
Picture 2 Picture 3
Kit List
1 x Tabletop
3 x Legs
3 x Screws
3 x Nuts, and Washers
1 x Circular Hinge
DON’T FORGET TO PAINT ON THE FURNITURE PROTECTOR AS SOON AS THE
PRODUCT IS ASSEMBLED, UNLESS ANOTHER FINISH IS TO BE APPLIED.
www.pepegarden.co.uk
1 | Sustainably Sourced & Ergonomically Designed

Picture 5
5. Flip and place at on the ground ready
to use (see picture 5) and enjoy the
Sunshine!
4. Once the legs are in place, screw and aached them into the tabletop using the pre-drilled holes.
When screwed in, tighten up each bolt connecting to the circular hinge (see pictures 4 and 5).
Picture 4 Picture 5
SUNSHINE TABLE
ASSEMBLY GUIDE
DON’T FORGET TO PAINT ON THE FURNITURE PROTECTOR AS SOON AS THE
PRODUCT IS ASSEMBLED, UNLESS ANOTHER FINISH IS TO BE APPLIED.
www.pepegarden.co.uk
2 | Sustainably Sourced & Ergonomically Designed