Perma 2747 User manual

INSTALLATION VIDEO
IMPORTANT! READ AND
FOLLOW THESE INSTRUCTIONS
CAREFULLY AND KEEP FOR
FUTURE REFERENCE.
This product complies with safety standard ASTM F1004-19.
Playpen
Barrier
29.5”
(75cm)
Tall
Fits Openings 28.8” to 144.6”
(73cm - 370cm)

2
TABLE OF
CONTENTS
SAFETY INFORMATION
General
Maintenance
Warnings
Mountings
WHAT’S IN THE BOX
Parts
INSTALLATION
Gate Placement
Underside Bracket Wall Assembly
Topside Bracket Wall Assembly
Room Divider or Safety Barrier
To Add Extra Panels
To Remove Unwanted Panels
Playpen Assembly
OPERATION
How to Open
Safety Play Mat
Cleaning Instructions
SUPPORT
Warranty Certicate
Warranty Card
After Sales Support
03
03
04
06
08
10
11
15
18
20
21
22
23
24
25
26
27
27

3
SAFETY
INFORMATION
Read this instruction manual carefully and keep it in a safe place for
future reference. The correct use and maintenance of this product is
essential.
Regularly check that the gate is functioning correctly, lubricate
hinges and moving components with a suitable spray lubricant.
Tighten and adjust mounts to ensure secure smooth operation.
Inspect all components regularly and stop using if any component is
damaged or missing.
GENERAL
MAINTENANCE

4
Incorrect tting or positioning of this safety barrier
can be dangerous.
Do not use the safety barrier if any components
are damaged, missing or disassembled.
Never install this product on glass doors or
windows.
Stop using the product if the child is able to climb,
dislodge or open barrier unassisted.
A maximum of 9 panels can be used when used
as a barrier/room divider.
Danger to older children if climbing over the barrier.
Regularly check that the barrier is properly xed
and secure.
Any additional or replacement parts should only be
obtained from after sales support.
This safety gate is suitable for openings from 73cm
(28.8”) to 370cm (145.6”).
Before using this product, carefully inspect for any
loose parts and whether any parts need to be
tightened.
Children have died or been seriously injured when
[gates/enclosures] are not securely installed.
ALWAYS install and use [gates/enclosures] as
directed using all required parts.
WARNING
WARNING
WARNING
WARNING
WARNING
WARNING
WARNING
WARNING
WARNING
WARNING
WARNING
WARNING
WHEN USED AS A SAFETY BARRIER
WARNINGS

5
This product is intended for use with children
from 6 to 24 months or small to medium pets
from 4.5kg (10 lbs) up to 18kg (40 lbs).
Do not use the playpen without the PERMA
Products play mat base.
Do not place the playpen close to an open re or
other heat source.
Do not leave anything in the playpen which
may provide a foothold or create a danger of
suffocation or strangulation.
This safety barrier is for domestic use only.
This safety barrier has a manual closing system.
Ensure that the playpen is fully erected and all the
locking mechanisms engaged before placing your
child in this playpen.
Do not use the playpen if any part is broken, torn
or missing and use only spare parts approved
by manufacturer, accessories which are not
approved by manufacturer shall not be used.
Check regularly that all assembly ttings are
tightened properly.
Use only with the locking/latching mechanism
securely engaged.
NEVER use to keep child away from pool.
WARNING
WARNING
WARNING
WARNING
WARNING
WARNING
WARNING
WARNING
WARNING
WARNING
WARNING
WHEN USED AS A PLAYPEN
WARNINGS

6
MOUNTINGS
Gate must be installed in a structurally sound opening.
Ensure mounting surface (wall, door frame, stair posts, etc.) is
strong, rigid and has an even surface.
Note: If using gate on stairs, it must be placed either on the top
step or on the lowest step at the bottom.
Select the appropriate xing method from the following list.
Drill 2mm (5/64’’) pilot holes
and use the wood screws pro-
vided screwing directly into the
wood.
WOOD MOUNTING
Locate the wood stud and
follow the wood mounting
instructions. Do not mount
into dry wall without
additional support.
DRY WALL MOUNTING
Wood Screws
FOR INSTALLATION
SAFETY INFORMATION

7
Drill 5mm (3/16’’) pilot holes,
insert anchor and secure with
screws.
Drill 5mm (3/16’’) pilot holes,
insert anchor and secure
with screws.
Wood Screws
Anchor
HARD WALL MOUNTING
BRICK
HARD WALL MOUNTING
CONCRETE
FOR
INSTALLATION
This gate must only be xed to a solid and secure surface. If unsure,
check with a qualied builder or trades person that the installation
you intend is suitable and safe within the chosen location.
PENCIL DRILL
TOOLS REQUIRED
PHILLIPS HEAD
SCREW DRIVER

8
5 x
Barrier Panels
1 x
Gate Panel
UNDERSIDE TOPSIDE
PARTS
WHAT’S IN THE BOX

9
1 x
Top Underside
Wall Bracket
2 x
Lower Wall Bracket
8 x
Screws
1 x
Top Cap
1 x
Top Topside
Wall Bracket
1 x
Bottom Cap
7 x
Corner Tubes
If any parts are missing do not attempt to use your Playpen Barrier.
Please contact us at www.permachildsafety.com/contact to obtain
replacements. Only use parts supplied by the manufacturer with
your Playpen Barrier.

10
STEP 1:
GATE PLACEMENT
INSTALLATION
STEP 1:
GATE PLACEMENT
As a Playpen;
In an open space
As a Barrier;
Across the room
SUITABLE PLACEMENT OF GATE AND CATCH MOUNT

11
Place the Lower Wall Bracket over Corner Tube, and then put
the Corner Tube into the Top Underside Wall Bracket.
Put the Top Underside Wall Bracket into the top of the Barrier
Panel, and the bottom into the bottom of the Barrier Panel, and
then into the Bottom Cap.
1.
2.
STEP 2: UNDERSIDE
BRACKET WALL ASSEMBLY
INSTALLATION

12
Mark screw hole positions with a pencil for the Top Underside
Wall Bracket and the Lower Wall Bracket.
Disassemble and screw in Top Underside Wall Bracket and
Lower Wall Bracket.
3.
4.

13
Reassemble gate panel by connecting the top of the Barrier
Panel to the Top Underside Wall Bracket.
5.

14
Place the Corner Tube through the Lower Wall Bracket.
Then place the Corner Tube into the Top Underside Wall
Bracket. Pull the Corner Tube up so you can position the
bottom of the Corner Tube into the bottom hole, and then into
the Bottom Cap.
6.
7.

15
Place the Lower Wall Bracket over Corner Tube, and put the
Top Cap on the bottom of the Barrier Panel.
Place the Corner Tube into the Barrier Panel and then into the
Top Topside Wall Bracket. Pull the Corner Tube up, while lifting
the bottom into its position.
1.
2.
STEP 3: TOPSIDE BRACKET
WALL ASSEMBLY
INSTALLATION

16
Mark screw hole positions with a pencil for the Top Topside
Wall Bracket and the Lower Wall Bracket.
Disassemble and screw in Top Topside Wall Bracket and then
screw in the Lower Wall Bracket.
3.
4.

17
Place the Corner Tube through the Lower Wall Bracket and
then push the Corner Tube through the top hole.
5.
Put the Top Cap on the bottom of the Barrier Panel, and then
position the Corner Tube in place.
6.

18
Up to 9 panels including the gate may be used in open
congurations providing the 2 end panels are securely xed to a wall
with the xings provided.
STEP 4: ROOM DIVIDER
OR SAFETY BARRIER
INSTALLATION

19

20
INSTALLATION
1. Align opposite ends of panels, place the Corner Tube into the
top hole rst, then pull the Corner Tube up so you can position
the bottom of the Corner Tube into the bottom hole.
LOCKED
UNLOCKED
STEP 5:
TO ADD EXTRA PANELS