PharmaTech Solutions GenUltimate! 4Pets Avantage Instruction manual

PharmaTech Solutions, Inc.
Westlake Village, CA
Blood Glucose Monitoring Kit
Quick User’s Guide
Avantage
Gen
Ultimate!®
4Pets
Calibrated for Canines, Felines, and Equines
Avantage!
mg/dL
mmol/L
dog
Cat
Day
Ave
GenUltimate!®4Pets Avantage
Meter Setup
Date
Before performing a test, set up the date, time,
and unit of measurement. Press the power
button to turn on the meter. Press and hold the
Λbutton on the front of the monitor to enter
the setting mode.
From the start, press Λor Vto change the year. When
the correct year appears on the display, press the power
button and move on to the next setting. Repeat process
twice for the month and day. Press the power button again
once finished to move on to the next setting,“Time”.
Time
First, change the hour setting. Press the Λor Vbutton to
change the hour. Once the correct hour appears on the
display, press the power button to move on to the minutes.
Repeat the same process and press the power button to
move on to the next setting,“Unit”.
Unit of Measurements
Press Λor V to change the unit of measurement.When
the desired unit appears on the display, press the power
button to save the setting.
Your meter is now set and ready to use. Follow the
steps on the other side of the Quick User’s Guide
to perform a test!
For additional information, please contact PharmaTech
Solutions Customer Service at: 1-833-737-7877
www.genultimate4pets.co
www.pharmatechsolutions.co
Year Month Day
Hour
Unit
Minutes
mg/dL
mmol/L

mg/dL
dog
X
Avantage!
X
dog
Avantage!
How to Perform a
Blood Glucose Test
1.
2.
These steps will show you how to properly perform a
blood glucose test with your GenUltimate!®4Pets
Avantage Meter and Test Strips!
Turn on the meter.Take out one (1) test strip from the container
and hold the meter as shown below. Insert the test strip all the
way into the test strip port.You must not bend, cut or alter the
test strip in any way. Use the test strip immediately after
removing it from the container.The code appears on the display.
The blinking drop of blood icon indicates the meter is ready
to test blood glucose. If the blinking drop of blood icon does not
appear, remove the unused test strip and try a new strip.
Wash your hands and the test site with warm
water and soap. Rinse and dry your hands
thoroughly. Use a sterile lancing device to collect
a drop of blood from the test site. Softly press or
massage your pets ear until a round drop of blood is
formed. If the blood smears or spreads, do not use the blood.
Wipe the area and softly squeeze another drop of blood or
collect blood from a different site.
3. Obtain a blood sample:
Hold the ear and touch the edge of the test strip to the drop of blood.
Keep the tip of the test strip in contact with the blood until the
confirmation window is filled with blood.
4. When the confirmation window is completely filled, a
beep is heard and a five-second (5) countdown appears
on the display.After five (5) seconds, the display shows
the test results.
5. The blood glucose value appears on the display along with the
unit of measurement, test date and time.The test results will
be displayed for one (1) minute and automatically saved in
the meter’s memory.
See our full user guide, instuctional video (located at www.genultimate4pets.co)
or the package insert for more detailed information on capillary sampling
and accuracy data.You can locate the user guide and package insert for
download at www.genultimate4pets.co/downloads.html.