Philips AZ 3013/00 User manual

CD Sound Machine AZ 3013/00/05
AZ 3014/05
Handling Chip Components and Safety ..........................1 - 1
Technical Specification & Measurement Setup ...............2 - 1
Service tools ....................................................................2 - 1
Service Measurement......................................................2 - 2
Connections and controls ................................................3 - 1
Block Diagram .................................................................4 - 1
Wiring Diagram................................................................4 - 2
Front Board
circuit diagram .........................................................5 - 1
layout diagram.........................................................5 - 2
Tuner Board
circuit diagram .........................................................6 - 1
layout diagram.........................................................6 - 2
Tuner adjustment ....................................................6 - 2
CD Board
circuit diagram .........................................................7 - 1
layout diagram.........................................................7 - 2
Audio Board
circuit diagram .........................................................8 - 1
layout diagram.........................................................8 - 2
Exploded view .................................................................9 - 1
Mechanical partslist .........................................................9 - 2
Electrical partslist...........................................................10 - 1
©3140 785 32410
Published by YT 0309 Service Audio Printed in The Netherlands Subject to modification
CLASS 1
LASER PRODUCT
TABLE OF CONTENTS
©Copyright 2001 Philips Consumer Electronics B.V. Eindhoven, The Netherlands
All rights reserved. No part of this publication may be reproduced, stored in a retrieval
system or transmitted, in any form or by any means, electronic, mechanical, photocopying,
or otherwise without the prior permission of Philips.

HANDLING CHIP COMPONENTS
1 - 1

TECHNICAL SPECIFICATIONS
GENERAL
Mains voltage -/00C : 230 V
-/05 : 240V
Mains frequency -/00C/05 : 50 Hz
Battery main set : 9 V (R14 x 6)
Power consumption : < 20 W (max.)
Dimension (W x H x D) : 294 x 145 x 245 mm
Weight : 2.4 Kg
AMPLIFIER
Output power mains : 2 x 1 W
battery : 2 x 1 W
Speaker impedance : 2 x 8 ohm
Frequency response : 100 Hz - 10 kHz (±3dB)
COMPACT DISC
Frequency response : 100 Hz - 10 kHz ±2dB
S/N ratio : 60 dB
Channel difference 1 kHz : 2 dB
Channel crosstalk 1 kHz : 40 dB
Laser wavelength : 780 ±20 nm
Laser light power : < 0.5 mW
TUNER - FM SECTION
Tuning range : 87.5 - 108 MHz
IF frequency : 10.7 MHz ±0.2 MHz
Sensitivity : 20 dBf at 26dB S/N
Selectivity : 30 dB at 300kHz
IF rejection : 50 dB
Image rejection : 20 dB
Crosstalk : 20 dB
TUNER - AM SECTION
Tuning range MW : 531 - 1602 kHz
IF frequency : 450 kHz ±1 kHz
Sensitivity MW : 4500 µV/m at 26dB S/N
Selectivity MW : 16 dB
IF rejection MW : 60 dB
Image rejection MW : 28 dB
2 - 1

2 - 2
SERVICE MEASUREMENT
Bandpass
250Hz-15kHz
e.g. 7122 707 48001
LF Voltmeter
e.g. PM2534
DUT
RF Generator
e.g. PM5326
S/N and distortion meter
e.g. Sound Technology ST1700B
Tuner SW
To avoid atmospheric interference all AM-measurements have to be carried out in a Faraday«s cage.
Use a bandpass filter (or at least a high pass filter with 250Hz) to eliminate hum (50Hz, 100Hz).
Ri=50Ω
Aerial replacement
Capacitor
R=50Ω
Bandpass
250Hz-15kHz
e.g. 7122 707 48001
LF Voltmeter
e.g. PM2534
DUT
S/N and distortion meter
e.g. Sound Technology ST1700B
Frame aerial
e.g. 7122 707 89001
Tuner AM (MW,LW)
To avoid atmospheric interference all AM-measurements have to be carried out in a Faraday«s cage.
RF Generator
e.g. PM5326
Ri=50Ω
Low pass filter 22kHz
L
R
LEVEL METER
e.g. Sennheiser UPM550
with FF-filter
S/N and distortion meter
e.g. Sound Technology ST1700B
DUT
CD
Use Audio Signal Disc SBC429 4822 397 30184 (replaces test disc 3)
L.P.F. = 13 th order filter 4822 395 30204

1 2 3 4 5 6 7 8
! 0 9
3 - 1
Top and front panels (See 1)
1VOLUME
– adjusts volume level
2DBB (Dynamic Bass Boost)
– enhances bass response
3Source selector
– selects source of sound CD or TUNER. Also the power off switch
4Display
– shows the CD and tuner functions
5FM•MW (AM)
– selects FM/ MW (AM) waveband
6LIFT TO OPEN
– opens/ closes the CD door
7PRESS TO PLAY 2;
– starts or pauses CD play
8STOP 9
– stops CD playback; erases a CD programme
9SEARCH ∞,§
CD: skips or searches a passage/track backwards or forward
Tuner: tunes to a station (up, down)
0PRESET +,–
– selects a preset station (up, down)
!PROG MODE
CD: – programmes and reviews programmed track numbers;
– plays tracks CD/ programme in random order;
– repeats a track/CD/ programme
Tuner: – programmes preset stations
Back Panel (See 1)
@Telescopic aerial
– to improve FM reception
#Voltage selector (inside battery compartment,
some versions only)
– adjust to match the local voltage 110/220V before plugging in the set
$Battery door
– to open battery compartment
%AC MAINS
– inlet for mains lead
3 x 2 R14 • UM2 • C-CELLS
@ $# %
CONNECTIONS AND CONTROLS
For more detail on operation instruction please visit Philips Audio internet site :
http://www.audio.philips.com