Philips AZ1137/55 User manual

AZ1137
EN User manual
Register your product and get support at
www.philips.com/welcome

a b c d e
gijkl fh
m
no

1 Important
Safety
Know these safety symbols
This ‘bolt of lightning’ indicates uninsulated material within your unit may cause
an electrical shock. For the safety of everyone in your household, please do not
remove product covering.
The ‘exclamation mark’ calls attention to features for which you should read the
enclosed literature closely to prevent operating and maintenance problems.
WARNING: To reduce the risk of fire or electric shock, this apparatus should not
be exposed to rain or moisture and objects filled with liquids, such as vases, should
not be placed on this apparatus.
CAUTION: To prevent electric shock, fully insert the plug. (For regions with
polarized plugs: To prevent electric shock, match wide blade to wide slot.)
a Read these instructions.
b Keep these instructions.
c Heed all warnings.
d Follow all instructions.
e Do not use this apparatus near water.
f Clean only with dry cloth.
g Do not block any ventilation openings. Install in accordance with the
manufacturer’s instructions.
h Do not install near any heat sources such as radiators, heat registers, stoves,
or other apparatus (including amplifiers) that produce heat.

i For countries with a polarized mains, do not defeat the safety purpose
of the polarized or grounding-type plug. A polarized plug has two blades
with one wider than the other. A grounding type plug has two blades and
a third grounding prong. The wide blade or the third prong is provided for
your safety. If the provided plug does not fit into your outlet, consult an
electrician for replacement of the obsolete outlet.
Caution: To prevent electric shock, match the wide blade of the plug to the
wide slot, fully insert.
j Protect the power cord from being walked on or pinched, particularly at
plugs, convenience receptacles, and the point where they exit from the
apparatus.
k Only use attachments/accessories specified by the manufacturer.
l Use only with the cart, stand, tripod, bracket, or table specified by the
manufacturer or sold with the apparatus. When a cart is used, use caution
when moving the cart/apparatus combination to avoid injury from tip-over.
m Unplug this apparatus during lightning storms or when unused for long
periods of time.
n Refer all servicing to qualified service personnel. Servicing is required when
the apparatus has been damaged in any way, such as power-supply cord
or plug is damaged, liquid has been spilled or objects have fallen into the
apparatus, the apparatus has been exposed to rain or moisture, does not
operate normally, or has been dropped.
o Battery usage CAUTION – To prevent battery leakage which may result in
bodily injury, property damage, or damage to the apparatus:
Install all batteries correctly, + and - as marked on the apparatus.•
Do not mix batteries (old and new or carbon and alkaline, etc.).•
Remove batteries when the unit is not used for a long time.•
The batteries shall not be exposed to excessive heat such as sunshine, fire•
or the like.
p Apparatus shall not be exposed to dripping or splashing.

q Do not place any sources of danger on the apparatus (e.g. liquid filled
objects, lighted candles).
r This product may contain lead and mercury. Disposal of these materials
may be regulated due to environmental considerations. For disposal or
recycling information, please contact your local authorities or the Electronic
Industries Alliance: www.eiae.org.
Warnings
Never remove the casing of this apparatus.•
Never lubricate any part of this apparatus.•
Never place this apparatus on other electrical equipment.•
Keep this apparatus away from direct sunlight, naked flames or heat.•
Never look into the laser beam inside this apparatus.•
Ensure that you always have easy access to the power cord, plug or adaptor to disconnect this•
apparatus from the power.
Where the MAINS plug or an appliance coupler is used as the disconnect•
device, the disconnect device shall remain readily operable.
Caution
Use of controls or adjustments or performance of procedures other than herein may result in•
hazardous radiation exposure or other unsafe operation.
Notice
Environmental information
All unnecessary packaging has been omitted. We have tried to make the packaging
easy to separate into three materials: cardboard (box), polystyrene foam (buffer)
and polyethylene (bags, protective foam sheet.)
Your system consists of materials which can be recycled and reused if disassembled
by a specialized company. Please observe the local regulations regarding the disposal
of packaging materials, exhausted batteries and old equipment.
Any changes or modifications made to this device that are not expressly approved
by Philips Consumer Lifestyle may void the user’s authority to operate the
equipment.
Recycling

Your product is designed and manufactured with high quality materials and
components, which can be recycled and reused.
When you see the crossed-out wheel bin symbol attached to a product, it means
the product is covered by the European Directive 2002/96/EC:
Never dispose of your product with other household waste. Please inform
yourself about the local rules on the separate collection of electrical and electronic
products. The correct disposal of your old product helps prevent potentially
negative consequences on the environment and human health.
Your product contains batteries covered by the European Directive 2006/66/EC,
which cannot be disposed of with normal household waste.
When you see the crossed-out wheel bin symbol with the chemical symbol ‘Pb’, it
means that the batteries comply with the requirement set by the directive for lead:
Please inform yourself about the local rules on separate collection of batteries. The
correct disposal of batteries helps prevent potentially negative consequences on the
environment and human health.
The making of unauthorized copies of copy-protected material, including computer
programs, files, broadcasts and sound recordings, may be an infringement of
copyrights and constitute a criminal offence. This equipment should not be used for
such purposes.
Recording and playback of material might require consent. See Copyright Act 1956
and The Performer’s Protection Acts 1958 to 1972.
This apparatus includes these labels:
Class II equipment symbol

This symbol indicates that the apparatus has a double insulation system.
2 Your CD Soundmachine
Congratulations on your purchase, and welcome to Philips! To fully benefit from the
support that Philips offers, register your product at www.philips.com/welcome.
Introduction
With the CD Soundmachine, you can:
play CDs, MP3/wma discs•
listen to FM/MW(AM) radio•
program the play sequence of tracks.•
What’s in the box
Check and identify the contents of the package:
Main unit•
AC power cord•
MP3 LINK cable•
User Manual•
aSource selector: CD, FM, MW, OFF.
Select CD, FM, MW(AM) source or turn off the unit•
b MP3 LINK
Socket for connecting an external device•
c Display panel
Show current status.•
d PUSH TO OPEN
Open or close the disc compartment.•
e TUNING+/-
Tune to radio stations•
f ALBUM+/-
For MP3-CDs: Skip to the next/previous album in an MP3-CD•
g
Start or pause play•

h /
Select the previous/next track•
Search backward/forward•
i
Stop play.•
Erase a program•
j MODE
Select a play mode: REPEAT or SHUFFLE•
k PROG
For MP3-CDs: Program tracks and browse the program•
l VOL+/-
Adjust volume level•
mTelescopic antenna
Adjust FM reception•
n AC MAINS
Jack for the supplied AC power cord•
o Battery compartment door
p Voltage selector
3 Get started
Caution
Use of controls or adjustments or performance of procedures other than herein may result in•
hazardous radiation exposure or other unsafe operation.
Always follow the instructions in this chapter in sequence.
If you contact Philips, you will be asked for the model and serial number of this
apparatus.The model number and serial number are on the bottom of the apparatus.
Write the numbers here:
Model No. __________________________
Serial No. ___________________________

Connect AC power
Caution
Risk of product damage! Ensure that the power supply voltage corresponds to the voltage printed•
on the back or the underside of the unit.
Warning
Risk of electric shock! When you unplug the AC adaptor, always pull the plug from the socket.•
Never pull the cord.
Notes
Install the apparatus near the power supply socket and where the AC power plug can be easily•
reached.
The type plate is located on the bottom of the main unit.
•
1 Switch the voltage selector at the bottom of the unit to the local power line
voltage.
2 Connect the power cord to the AC~ MAINS socket on the apparatus and to
the power supply socket.
To save energy: After use, set the switch to OFF.
220V-
240V
110V-
127V

Install batteries
Notes
You can use both batteries and AC power as power supply of this apparatus.•
Batteries are not supplied with the accessories.•
1 Open the battery compartment.
2 Insert 6 x 1.5V R14/UM-2/C-cell batteries with correct polarity (+/-) as
indicated.
3 Close the battery compartment.

4 Play a CD
Note
You cannot play CDs encoded with copyright protection technologies.•
You can play commercially available audio CDs:
CD-Recordables (CD-R)•
CD-Rewritables (CD-RW)•
MP3-CDs•
WMA-CDs•
1 Switch the source selector to CD.
2 Open the CD compartment.
3 Insert a CD with the printed side facing up and close the CD lid gently.
The total number of tracks displays.»
4 Press to start play.
»[] displays.
To select a track,press• / .
To pause CD play, press• .
To resume CD play, press• again.
To stop CD play, press• .
Find a passage within a track
1 During play, press and hold / .
The CD plays at high speed and with reduced volume.»
2 Release / to resume normal play.
Tip
When search reaches the end of the last track, the CD stops.•
Select an album
For MP3-CDs only.
1 During play, press ALBUM+/- to select an album.

Select play modes
1 Press MODE repeatedly to select a play mode:
• [] (repeat) – repeat a track
• [ALL] (repeat all) - repeat an entire CD/program
• [] (shuffle) - play tracks randomly
2 To return to normal play, press MODE repeatedly until play mode icons are no
longer displayed.
Tip
Shuffle play cannot be selected when you play programmed tracks.•
Program play sequence
You can store up to 20 tracks in the desired sequence.
1 In stop mode, press PROG to start to program play sequence.
»[PROG] and [P01] are displayed.
2 For MP3-CDs: press ALBUM+/- to select an album.
3 Press / to select a track.
4 Press PROG to store the track.
»[PROG] and [P02] are displayed.
5 Repeat steps 2 to 4 to select and store all tracks.
When all 20 tracks are stored, no more tracks can be selected and the»
display shows [PROG] and [---].
6 To play program, press .
In stop mode, press• PROG repeatedly to browse stored tracks.
To cancel program, press• twice.
Tip
When program play stops, the apparatus returns to normal play. To play program again, repeat•
steps 1 to 6.
5 Listen to an external device
You can listen to an MP3 player through this apparatus.

Note
When you connect an external device to• MP3 LINK jack, the apparatus switches to
MP3 LINK source automatically.
1 Use an MP3 link cable (supplied) to connect MP3 LINK jack (3.5mm) on this
apparatus and the headphone jack on an MP3 player.
6 Listen to radio
1 Switch the source selector to FM or MW (AM).
2 Turn TUNING+/- until you find optimal reception.
Tips
To improve FM reception, you can extend, incline or turn the telescopic antenna for best•
reception.
To improve MW reception, turn the apparatus to face a different direction.
•
7 Product information
Note
Product information is subject to change without prior notice.•
Dimensions (W x H x D) 341 x 122 x 236 mm
Weight (main unit) 1.67 kg
Power supply DC 9V 1.5 A
AC 110-127V, 60Hz
220-240V, 50Hz
Power consumption Active <12 W
Power output 2 x 1 W RMS
Operating temperature range -10 °C - 50 °C
14 °F -122 °F

8 Troubleshooting
Troubleshooting
Warning
Never remove the casing of this apparatus.•
To keep the warranty valid, never try to repair the system yourself.
If you encounter problems when using this apparatus, check the following points before
requesting service. If the problem remains unsolved, go to the Philips web site (www.
Philips.com/support).When you contact Philips, ensure that the apparatus is nearby and
the model number and serial number are available.
No power
Ensure that the Mains cord is connected securely.•
Ensure that there is power at the AC Mains.•
Ensure that the batteries are inserted correctly.•
No sound
Adjust the volume.•
Ensure that the track played is of a compatible format.•
Display does not function properly./No reaction to any operation of the controls.
1 Disconnect the AC power cord.
2 Connect the AC power cord after a few seconds.
Cannot play disc
Ensure that the disc label is inserted with the printed side facing up.•
Wipe the disc with fibre cleaning cloth from the centre to the edge in a•
straight line.
This disc may be defective. Play another disc.•
Ensure that the CD is a finalised CD/CD-R/CD-RW.•
Ensure that the laser lens is clean.•
Ensure that the CD is not encoded with copyright protection technologies.•
The CD skips tracks
Ensure that the CD is not damaged or dirty.•
Ensure that program/shuffle mode is deactivated.•

© 2009 Koninklijke Philips Electronics N.V.
All rights reserved.
Document order number:AZ1137_55_UM_V1.0