In-car connections (supplied or optionally available)
Use only theAY 3545 or AY 3548 car voltage converter (4.5V DC, positive
pole to the centre pin) and the AY 3501 car adapter cassette.Any other
product may damage the set.
1Put the set on a horizontal,vibration-free and
stable surface. Make sure it is in a safe place,
where the set is neither a danger nor an
obstacle to the driver and the passengers.
2Plug the voltage converter into the cigarette
lighter socket (only for a 12V car battery,
negative grounding),then connect the
wired end with the 4.5V DC input socket on
the set.
3If necessary,clean the cigarette lighter socket to obtain a good electrical
contact.
4Turn down the volume and connect the adapter cassette plug to
LINE OUT/pon the set.
5Carefully insert the adapter cassette into the car radio’s cassette
compartment.
6Make sure the cord does not hinder your driving.
7SetVOL Eon the set to position 8.Start playback on the set and adjust
the sound with the car radio controls.
Always remove the voltage converter from the cigarette lighter socket
when the set is not in use.
Note:If your car radio has a LINE IN socket,it is better to connect the set to
this socket instead of using the adapter cassette.Connect LINEOUT/pof the
set with the LINE IN socket of your car radio with an appropriate cable.
25
Accessories
English
ESP and powersaving
With a conventional portable disc player
the music may stop while you are jogging,for
example.The Electronic Skip Protection
protects this set against loss of sound caused
by light vibrations or shocks.Continuous
playback is ensured.ESP does not protect
the set against damage caused by
dropping!
●Press ESP repeatedly during playback to select
either:
–ESP on: is shown and ESP is
switched on.
–Longer battery playing time:
is shown.ESP and powersaving are switched on,resulting in
a longer battery lifetime and a shorter skip protection.
–ESP off: disappears. ESP and powersaving are switched off
for CDAudio tracks to achieve the highest sound quality.
Beep
A beep confirms that you have pressed a
button or that the batteries are empty.
●Keep DBB/TREBLE pressed for 2 seconds to
switch beep either on or off:
➜Beep is displayed:Beep is switched on.
➜No beep is displayed:Beep is switched off.
24
Features
English