Philips AJ4000B User manual

33
MIN
AJ4000B
www.philips.com/welcome
User Manual
BUZ
AL 1
RADIO AL 2
15 30 60 90 120
OFF
SLEEP
1 2
SET TIME
4
CLOCK
MIN
3
3
HR
MIN
1 2
2
32 4
TUNING
OFF
VOL
RADIO
2
21 2 21
SET AL 1 SET AL 2
2
22
HR
2
22
HR
2
22
2
21
b
ad
hj
g
l
ki
ec
f
2
21 2 22
ALARM
RESET
SNOOZE
33
MIN
Always there to help you
Register your product and get support at
www.philips.com/welcome
AJ4000B
User manual
All registered and unregistered trademarks are property of their
respective owners.
© 2012 Koninklijke Philips Electronics N.V.
All rights reserved.
AJ4000B_05_UM_V1.0
AJ4000B_05_UM_V1.0.indd 1AJ4000B_05_UM_V1.0.indd 1 11/23/2012 9:50:27 AM11/23/2012 9:50:27 AM

EN
1 Important
• Read these instructions.
• Heed all warnings.
• Follow all instructions.
• Do not block any ventilation openings. Install in accordance with the
manufacturer’s instructions.
• Do not install near any heat sources such as radiators, heat registers,
stoves, or other apparatus (including amplifiers) that produce heat.
• Protect the power cord from being walked on or pinched,
particularly at plugs, convenience receptacles, and the point where
they exit from the clock radio.
• Only use attachments/accessories specified by the manufacturer.
• Unplug this clock radio during lightning storms or when unused for
long periods of time.
• Refer all servicing to qualified ser vice personnel. Servicing is required
when the clock radio has been damaged in any way, such as power-
supply cord or plug is damaged, liquid has been spilled or objects
have fallen into the clock radio, the clock radio has been exposed to
rain or moisture, does not operate normally, or has been dropped.
• Battery usage CAUTION – To prevent battery leakage which may
result in bodily injury, property damage, or damage to the clock
radio:
• Install the battery correctly, + and - as marked on the clock radio.
• Remove the battery when the clock radio is not used for a long
time.
• The battery shall not be exposed to excessive heat such as
sunshine, fire or the like.
• This clock radio shall not be exposed to dripping or splashing.
• Do not place any sources of danger on the clock radio (e.g. liquid
filled objects, lighted candles).
• Where the plug of the Direct Plug-in Adapter is used as the
disconnect device, the disconnect device shall remain readily
operable.
2 Your clock radio
Congratulations on your purchase, and welcome to Philips!To fully
benefit from the support that Philips offers, register your product at
www.philips.com/welcome.
What’s in the box
Check and identify the contents of your package. (Fig. )
3 Get started
Always follow the instructions in this chapter in sequence.
Install battery
Caution
• Risk of explosion! Keep the battery away from heat, sunshine or fire. Never
discard battery in fire.
• The battery contains chemical substances, so it should be disposed of
properly.
Insert one 9V 6F22 battery (not supplied) with correct polarity (+/-) as
illustrated. (Fig .)
Note
• The battery can only back up clock and alarm settings.
Connect power (Fig. )
Caution
• Risk of product damage! Make sure that the power voltage corresponds to
the voltage printed on the back or underside of the clock radio.
• Risk of electric shock! When you unplug the power adapter, always pull the
plug from the socket. Never pull the cord.
Note
• The type plate is located at the bottom of the clock radio.
Set clock (Fig. )
1 Switch the slider to SET TIME.
» The hour and minute digits blink.
2 Press HR and MIN to adjust time.
3 Switch the slider to CLOCK to confirm the setting.
4 Listen to FM radio
Note
• Keep the clock radio away from other electronic devices to avoid radio
interference.
• For better reception, fully extend and adjust the position of the FM antenna.
Tune to FM radio stations (Fig .)
1 Switch the slider to RADIO.
2 Rotate TUNING to select a station.
» The indicator shows the radio frequency of the waveband.
3 While listening, rotate VOL to adjust volume.
4 Switch the slider to OFF to turn off the radio.
5 Set alarm timer
Set alarm
Follow the illustration to set the alarm (Fig. )
• AL1: Set the first alarm.
• AL2: Set the second alarm.
Select alarm source (Fig. )
To select the last heard channel or buzzer as the alarm sound:
• AL1: Switch the slider to RADIO or BUZ.
• AL2: Switch the slider to RADIO or BUZ.
» The corresponding alarm icon lights up.
Note
• The gentle wake-up function is available for buzzer only.
Deactivate the alarm timer
Switch AL1 or AL2 to OFF to deactivate the alarm clock.
» If the alarm timer is deactivated, the alarm indicator turns off.
Snooze the alarm (Fig. )
1 When alarm sounds, press SNOOZE .
» The alarm snoozes and repeats ringing nine minutes later.
2 To reset the alarm, press ALARM RESET.
» The alarm repeats ringing for the next day.
6 Other features
Adjust brightness (Fig. )
Set sleep timer (Fig. )
1 Press SLEEP repeatedly to set the sleep time.
» The radio turns on automatically.
2 To check the remaining sleep time, press SLEEP again.
To deactivate the sleep timer:
• Press SLEEP repeatedly until [OFF] appears.
Charge your mobile phone
You can use this device to charge your mobile phone.
Note
• Make sure that the USB socket and the Micro USB are used only for
charging.
• Some USB cables may not work with this device due to different
materials.
• The USB charging and Micro USB charging are available when AC
power is connected.
Option 1 :USB socket (Fig. )
Note
• The USB cable is not supplied.
Option 2 : Micro USB (Fig. )
7 Product information
Note
• Product information is subject to change without prior notice.
Specifications
Amplifier
Rated Output Power 300mW RMS
Tuner (FM)
Tuning Range 87.5 - 108MHz
Sensitivity
- Mono, 26dB S/N Ratio <22 dBf
Total Harmonic Distortion <3%
Signal to Noise Ratio >45dB
General information
AC power (power adapter) Brand name: Philips;
Model: AS100-065-AI130;
Input: 100-240 V~, 50/60 Hz; 0.5A;
Output: 6.5 V 1.3 A
Battery power 9 V
Operation Power Consumption 11 W
Standby Power Consumption <1 W
USB Charge Voltage DC 5V
Micro USB Charge Voltage DC 5V
Dimensions:
Main Unit (W x H x D) 173x 64x 159 mm
Weight:
-Main Unit 0.5 kg
8 Troubleshooting
Warning
• Never remove the casing of this apparatus.
To keep the warranty valid, never try to repair the system yourself.
If you encounter problems when using this apparatus, check the
following points before requesting service. If the problem remains
unsolved, go to the Philips web site (www.philips.com/support). When
you contact Philips, ensure that the apparatus is nearby and the model
number and serial number are available.
No power
•Ensure that the AC power plug of the unit is connected properly.
•Ensure that there is power at the AC outlet.
No sound
•Adjust the volume.
No response from the unit
•Disconnect and reconnect the AC power plug, then turn on the unit
again.
Poor radio reception
•Increase the distance between the unit and yourTV or VCR.
•Fully extend the FM antenna.
Alarm does not work
•Set the clock/alarm correctly.
Clock/alarm setting erased
•Power has been interrupted or the power plug has been
disconnected.
•Backup battery is used up.
•Reset the clock/alarm.
No charging
•Use the USB cable bypacked with your device for charging.
9 Notice
Any changes or modifications made to this device that are not expressly
approved by Philips Consumer Lifestyle may void the user’s authority to
operate the equipment.
This product complies with the radio interference requirements
of the European Community.
Your product is designed and manufactured with high quality
materials and components, which can be recycled and reused.
When this crossed-out wheeled bin symbol is attached to a
product it means that the product is covered by the European
Directive 2002/96/EC.
Please inform yourself about the local separate collection system
for electrical and electronic products.
Please act according to your local rules and do not dispose of your old
products with your normal household waste. Correct disposal of your
old product helps to prevent potential negative consequences for the
environment and human health.
Your product contains batteries covered by the European
Directive 2006/66/EC, which cannot be disposed with normal
household waste.Please inform yourself about the local rules
on separate collection of batteries because correct disposal helps to
prevent negative consequences for the environmental and human
health.
Environmental information
All unnecessary packaging has been omitted.We have tried to make
the packaging easy to separate into three materials: cardboard (box),
polystyrene foam (buffer) and polyethylene (bags, protective foam
sheet.)
Your system consists of materials which can be recycled and reused
if disassembled by a specialized company. Please observe the local
regulations regarding the disposal of packaging materials, exhausted
batteries and old equipment.
2012 © Koninklijke Philips Electronics N.V. All rights reserved.
Specifications are subject to change without notice.Trademarks are
the property of Koninklijke Philips Electronics N.V. or their respective
owners. Philips reserves the right to change products at any time
without being obliged to adjust earlier supplies accordingly.
AJ4000B_05_UM_V1.0.indd 2AJ4000B_05_UM_V1.0.indd 2 11/23/2012 9:51:02 AM11/23/2012 9:51:02 AM