Philips Norelco 6000 Series User manual

S6880, S6850,
S6820, S6810
Tripleheader shaver
BC

S6850
S6880
S6820
S6850
S6880
S6820
S6810
S6810
3
4
2
7
17
18
8
10 11
12
13
14
15
9
19
16 20
S6810
S6850
1
6
5

empty page before TOC

English 6
Español 37

English
IMPORTANT SAFETY
INSTRUCTIONS
When using an electric product, basic
precautions should always be followed,
including the following:
Read all instructions before using this
product.
DANGER
To reduce the risk of electric shock:
-Do not reach for a corded product or
charging stand that has fallen into water.
Unplug immediately from the power outlet.
-Keep the power cord and charging stand
dry.
-Do not place or store the product or
charging stand where it can fall or be pulled
into a tub or sink. Do not place or drop the
product or charging stand into water or
other liquid.
-Except when charging, always unplug this
product from the power outlet immediately
after use.
-Remove power cord from power outlet and
product before cleaning.
-Plug power cord directly into power outlet.
Do not use an extension cord.
6English

WARNING
To reduce the risk of burns, fire, electric
shock, or injury to persons:
-Close supervision is required when this
product is used by, on, or near children, or
persons with limited physical, sensory, or
mental capabilities or invalids.
-Use this product only for its intended
household use as described in this manual.
Do not use attachments not recommended
by Philips North America LLC.
-Never operate the product or charging
stand if it has a damaged power cord, if it is
not working properly, after it has been
dropped or damaged, or after the product
or power cord has been dropped into water.
For assistance call 1-800-243-3050.
-Keep the power cord away from heated
surfaces.
-Never drop or insert any object into any
opening.
-Do not use the power cord in or near a
power outlet that contains an electric air
freshener to prevent damage to the power
cord.
-Do not charge or plug in product or
charging stand outdoors or operate where
aerosol (spray) products are being used or
where oxygen is being administered.
7
English

-Always check cutters, cutting unit and
guards before using the product. Do not use
the product if cutters, cutting unit or guards
are damaged, as injury may occur.
-Always attach power cord to product or
charging stand first, then to power outlet.
To disconnect, set all controls to 'off'
position. Then remove power cord from
power outlet.
-Unplug power cord before plugging in or
unplugging the product.
-Only use the power cord and other
accessories supplied with the product.
-Do not attempt to open the product to
remove or replace the built-in rechargeable
battery.
-The batteries used in this product may
present a fire or chemical burn hazard if
mistreated. Do not disassemble, heat above
100°C (212°F) or incinerate.
IMPORTANT: The power plug contains a
transformer. Do not cut off the power plug to
replace it with another plug as this will cause a
hazardous condition.
SAVE THESE
INSTRUCTIONS
Contents
IMPORTANT SAFETY INSTRUCTIONS___ 6
General description (Fig. 1)_______________ 9
8English

Introduction______________________________ 10
The display_______________________________ 10
Charging__________________________________ 13
Using the shaver_________________________ 15
Using click-on attachments______________ 19
Travel lock________________________________ 23
Cleaning and maintenance______________ 24
Replacement_____________________________ 31
Storage___________________________________ 32
Accessories_______________________________ 33
Assistance________________________________ 33
Disposal__________________________________ 33
Full Two-Year Warranty__________________ 34
45-DAY MONEY-BACK GUARANTEE____ 35
General description (Fig. 1)
1 Click-on precision trimmer (S6880, S6850,
S6820 only)
2 Protective cap for shaving unit (S6880,
S6850 only)
3 Click-on beard styler (S6810 only)
4 Comb for beard styler (S6810 only)
5 Click-on nose trimmer (S6850 only)
6 Protective cap for nose trimmer (S6850
only)
7 Shaving unit with hair chamber
8 On/off button
9 SkinGuard mode
10 Cleaning reminder
11 Replacement reminder
12 Travel lock symbol
13 'Unplug for use' reminder
14 Battery charge indicator
9
English

15 Socket for small plug
16 Charging stand (S6810 only)
17 Power plug
18 Small plug
19 Cleaning brush
20Travel case (S6820, S6810 only)
Note: The accessories supplied may vary for
different products. The box shows the
accessories that have been supplied with your
product.
Introduction
Congratulations on your purchase and
welcome to Philips Norelco!
To fully benefit from the support that Philips
Norelco offers, register your product at
www.norelco.com/register.
The display
Battery charge indicator
Quick charge: When the battery is empty and
you connect the shaver to an electrical outlet,
the lights of the battery charge indicator light
up white one after the other repeatedly. When
the battery contains enough energy for one
shave, the bottom light of the battery charge
indicator starts flashing white slowly.
10 English

As charging continues, each light will blink and
then light up continuously to indicate what
level the battery has been charged.
Battery fully charged
When the battery is fully charged, all lights of
the battery charge indicator light up white
continuously.
Note: When you press the on/off button while
the shaver is still connected to the power
outlet, the 'unplug for use' symbol lights up to
remind you to disconnect the shaver from the
power outlet before you can switch it on.
Note: When the battery is full, the display
switches off automatically after 30 minutes.
Battery low
When the battery is almost empty, the bottom
light of the battery charge indicator flashes
orange. At this point there is enough energy
left for one shave.
11
English

Remaining battery charge
The remaining battery charge is indicated by
the lights of the battery charge indicator that
light up continuously.
’Unplug for use’ reminder
The ‘unplug for use’ symbol flashes to remind
you to disconnect the shaver from the power
outlet before you can switch it on.
Cleaning reminder
Clean the shaver after every use for optimal
performance (see 'Cleaning and maintenance').
When you switch off the shaver, the cleaning
reminder flashes to remind you to clean the
shaver.
Travel lock
When you are going to travel, you can lock the
shaver to prevent it from accidentally turning
on.
12 English

Replacement reminder
For maximum shaving performance, replace
the shaving heads every year. The shaver is
equipped with a replacement reminder that
flashes to remind you to replace the shaving
heads.
Note: After replacing the shaving heads, you
can reset the replacement reminder by
pressing the on/off button for 7 seconds. If you
do not reset the replacement reminder, the
shaver resets automatically after 9 shaves.
SkinGuard mode
This mode reduces the rotation speed of the
shaver (see 'Shaving with SkinGuard mode').
Charging
-Charging, recharging, or using the product
at temperatures below 40°F (4.5°C) or
higher than 95°F (35°C) adversely affects
the lifespan of the battery.
-Do not charge the shaver in a pouch or
travel case.
-The power plug transforms 100-240V AC to
less than 24V DC.
Charge the shaver before you use it for the first
time and when the display indicates that the
battery is almost empty.
13
English

Charging takes approx. 1 hour. A fully charged
shaver has a shaving timeof up to 50 minutes.
Note: You cannot use the shaver while it is
charging.
Quick charge
After approx. 5 minutes of charging, the shaver
contains enough power for one shave. The
bottom light of the battery charge indicator
starts flashing white slowly when the quick
charge is finished.
Charging with the power cord
1Make sure the shaver is switched off.
2Put the small plug in the shaver and
connect the power plug to any 100V to
240V AC outlet. Use only the power cord
provided.
The display of the shaver indicates the
product is charging.
3After charging, remove the power plug from
the wall outlet and pull the small plug out of
the shaver.
Charging in the charging stand (S6810 only)
Note: The shaver can also be charged with the
power cord (see 'Charging with the power
cord').
1Make sure the shaver is switched off.
14 English

2Insert the small plug into the charging stand
connect the power plug to any 100V to
240V AC outlet. Use only the power cord
provided.
3Put the shaver in the charging stand.
4After charging, remove the power plug from
the wall outlet and pull the small plug out of
the charging stand.
Note: An adapter plug may be necessary for
cord usage in some foreign countries. Use an
attachment plug adapter of the proper
configuration for power outlet.
Using the shaver
Always check the shaver and all accessories
before use. Do not use the shaver or any
accessory if it is damaged, as this may cause
injury. Always replace a damaged part with
one of the original type.
This symbol indicates that the shaver can be
used in the bath or shower.
-Use this shaver for its intended household
use as described in this manual.
-For hygienic reasons, the shaver should
only be used by one person.
-Trimming is easier when the skin and hair
are dry.
15
English

Put it to the test
-21 Day Trial and Conversion Process. It is a
fact that your skin and beard need time to
adjust to a new grooming system.
-Use your new shaver exclusively for 3 weeks
to fully enjoy the closeness of a Philips
Norelco shave.
-At first you may not get as close a shave as
you expect, or your face may even become
slightly irritated. This is normal since your
beard and skin will need time to adjust.
Invest 3 weeks and you'll soon experience
the full joy of your new shaver.
-Stick with it! If you alternate shaving
methods during the adjustment period, it
may make it more difficult to adapt to the
Philips Norelco shaving system.
-If you are still not convinced after 21 days,
Philips Norelco will refund you the full
purchase price as long as the request is
received within 45 days of purchase.
Switching the shaver on and off
1To switch the shaver on or off, press the
on/off button once.
The display lights up for a few seconds to
show the battery status.
Note: This shaver is waterproof. It is suitable
for use in the bath or shower and for cleaning
under the tap. For safety reasons, the shaver
can only be used without charging cord.
16 English

Shaving
-For the best results on skin comfort, pre-
trim your beard if you have not shaved for 3
days or longer.
Dry shaving
1Switch the shaver on.
2Move the shaving heads over your skin in
circular movements to catch all hairs
growing in different directions. Make sure
each shaving head is fully in contact with
the skin. Exert gentle pressure for a close,
comfortable shave.
Note: Do not press too hard, as this can
cause skin irritation.
3Switch off and clean the shaver after each
use.
The display lights up for a few seconds to
show the battery status.
Wet shaving
For a more comfortable shave, you can also
use this shaver on a wet face with shaving
foam or shaving gel.
1Apply some water to your skin.
17
English

2Apply shaving foam or shaving gel to your
skin.
3Rinse the shaving unit under the tap to
ensure that the shaving unit glides smoothly
over your skin.
4Switch on the shaver.
5Move the shaving heads over your skin in
circular movements to catch all hairs
growing in different directions. Make sure
each shaving head is fully in contact with
the skin. Exert gentle pressure for a close,
comfortable shave.
Note: Do not press too hard, as this can
cause skin irritation.
Note: Rinse the shaving unit regularly to
ensure that it continues to glide smoothly
over your skin.
6Dry your face.
7Switch off and clean the shaver after each
use (see 'Cleaning and maintenance').
Note: Make sure that you rinse all foam or
shaving gel off the shaver.
Shaving with SkinGuard mode
This mode reduces the rotation speed of the
shaver.
18 English

1Switch on the shaver.
2Press the SkinGuard button once if you
want to shave at a lower rotational speed.
3Move the shaving heads over your skin in
circular movements to catch all hairs
growing in different directions. Make sure
each shaving head is fully in contact with
the skin. Exert gentle pressure for a close,
comfortable shave.
Note: Do not press too hard, as this can
cause skin irritation.
4Switch off the SkinGuard mode and return
the shave to normal speed, by pressing the
SkinGuard button once.
Note: Shaver runs at normal speed
automatically when switched on for each
new shave.
Using click-on attachments
Note: The accessories supplied may vary for
different products. The box shows the
accessories that have been supplied with your
product.
Removing or attaching click-on attachments
1Make sure the shaver is switched off.
19
English

2Pull the attachment straight off the
appliance.
Note: Do not twist the attachment while you
pull it off the appliance.
3Insert the lug of the attachment into the slot
in the top of the appliance. Then press
down the attachment to attach it to the
appliance (‘click’).
Using the precision trimmer attachment (S6820,
S6850, S6880 only)
You can use the precision trimmer attachment
to touch up your beard, sideburns and
mustache.
1Attach the trimmer to the product ('click').
2Switch on the product.
3Hold the trimmer perpendicular to the skin
and move it downwards while exerting
gentle pressure.
4Switch off and clean the attachment after
use.
Using the beard styler attachment with comb (S6810
only)
You can use the beard styler with the comb
attached to style your beard at one fixed
setting or at different length settings. You can
20 English