Philips S1030 Assembly instructions

Tripleheader shaver
S1030
Tripleheader shaver

1
2
3
4
6
5

empty page before TOC

English 6
Español 22

English
Contents
IMPORTANT SAFETY INSTRUCTIONS______________________ 6
General Description (Fig.1)__________________________________ 8
Introduction_________________________________________________ 9
Charging_____________________________________________________ 9
Using the product___________________________________________ 10
Cleaning and maintenance_________________________________ 14
Replacement________________________________________________ 16
Storage______________________________________________________ 18
Accessories__________________________________________________ 18
Assistance___________________________________________________ 18
Disposal_____________________________________________________ 19
Full Two-Year Warranty_____________________________________ 19
IMPORTANT SAFETY
INSTRUCTIONS
When using an electric product, basic precautions should
always be followed, including the following:
Read all instructions before using this product.
DANGER
To reduce the risk of electric shock:
-Do not reach for a corded product that has fallen into water.
Unplug immediately from the power outlet.
-Keep the power cord dry.
6English

-Do not place or store the product where it can fall or be
pulled into a tub or sink. Do not place or drop the product
into water or other liquid.
-This product does not work while it is connected to the
power outlet. Except when charging, always unplug this
product from the power outlet.
-Remove power cord from power outlet and product before
cleaning.
WARNING
To reduce the risk of burns, fire, electric shock, or injury to
persons:
-Close supervision is required when this product is used by,
on, or near children, or persons with limited physical, sensory,
or mental capabilities or invalids.
-Use this product only for its intended household use as
described in this manual. Do not use attachments not
recommended by Philips North America LLC.
-Never operate this product if it has a damaged power cord, if
it is not working properly, after it has been dropped or
damaged, or after the product or power cord has been
dropped into water. For assistance call 1-800-243-3050.
-Keep the power cord away from heated surfaces.
-Never drop or insert any object into any opening.
7
English

-Do not use the power cord in or near a power outlet that
contains an electric air freshener to prevent damage to the
power cord.
-Do not use product outdoors or operate where aerosol
(spray) products are being used or where oxygen is being
administered.
-Always check shaving heads (caps and cutters) before using
the product. Do not use the product if cutters or caps are
damaged, as injury may occur.
-Always attach power cord to product first, then to power
outlet.
-Plug power cord directly into power outlet. Do not use an
extension cord.
-Unplug power cord before plugging in or unplugging the
product.
-Only use the power cord and other accessories supplied with
the product.
-Do not attempt to open the product to remove or replace the
built-in rechargeable battery.
-The batteries used in this product may present a fire or
chemical burn hazard if mistreated. Do not disassemble, heat
above 100°C (212°F) or incinerate.
IMPORTANT: The power plug contains a transformer. Do not
cut off the power plug to replace it with another plug as this will
cause a hazardous condition.
SAVE THESE
INSTRUCTIONS
General Description (Fig.1)
1 Protection cap
8English

2 Shaving unit
3 On/off button
4 Charging light
5 Power cord with plug
6 Small plug
Introduction
Congratulations on your purchase and
welcome to Philips Norelco!
To fully benefit from the support that Philips
Norelco offers, register your product at
www.philips.com/register.
Charging
-Charging or using the product at
temperatures below 40°F (4.5°C) or higher
than 95°F (35°C) adversely affects the
lifespan of the battery.
-Do not charge the shaver in a pouch or
travel case.
-The power plug transforms 100-240V AC to
less than 24V DC.
Charging with the power cord
Note: You cannot use the shaver while it is
charging.
When you charge the shaver for the first time
or after a long period of disuse, let it charge for
at least 10 hours.
A fully charged shaver provides up to 45
minutes of shaving time.
9
English

1Make sure the product is turned off.
2Put the small plug in the shaver and
connect the power plug to any 100V to
240V AC outlet. Use only the power cord
provided.
The display of the shaver indicates that the
shaver is charging.
3After charging, remove the power plug from
the wall outlet and pull the small plug out of
the product.
Charge indications
Battery low
When the battery is almost empty, the shaver
starts working more slowly.
Charging
When the shaver is charging, the charging light
lights up white continuously.
The charging light will remain illuminated when
the shaver is fully charged.
Note: After charging, remove the power cord
from the wall socket and pull the small plug
out of the shaver.
Using the product
Always check the product and all
accessories before using. Do not use the
10 English