Philips UHP UX21511 User manual

PHILIPSUHPUX2I5I I , UX2I5I3, UX2I5I7, UX2I5I8
Replacement Lamp for Hitachi® LCD Rear Projection Television
User Instructions
CAUTION;
Do not attempt to remove the lamp Immediately after use; doing so can cause serious burns. Prior to removing lamp, switch off
the power supply to the television and wait approximately 60 minutes or more to allow for complete tamp cooling.
Avoid touching the glass portion(s) of the lamp with bare hands; fingerprints, dirt and dust may cause early lamp failure and/or
image obscurity. It is recommended that gloves be worn when replacing the lamp.
When transporting the replacement lamp, use the box that is provided to avoid breakage.
ARNING:
• To avoid overheating and/or fire, ensure that the replacement lamp is mounted securely.
• Hg - LAMP CONTAINS MERCURY, Manage in Accord with Disposal Laws. See; Nvww.lamprecycle.org or
1-877-977-0755. ^
Replacing the Lamp
0
01
Switch off power to the television. Unplug the power cord from the wall outlet. Allow the television to
cool for at least I hour.
Remove the front cover of the television by pulling it
outwards until the snap unlatches.
Remove the two screws on the lamp unit.
Using a Phillips head screwdriver, remove the screw
securing the kmp cover; remove the cover.
Remove the lamp unit from the television by
grasping the handle and pulling straight out. Slowly
remove the entire lamp assen^ly unit from the
television. Dispose of lamp in accordance with
disposal laws.
Note: To avoid injury, exercise caution when
removing the lamp unit and do not place your hand
in the lamp storage area.
PHILIPS
SALE on Projector Bulbs at www.BulbAmerica.com
take additional 5% Off with coupon code 5PDF

1
Insert the new lamp unit, paying attention to the
orientation and direction of insertion. Ensure that the
new unit is firmly seated.
Note: To avoid shortened lamp life and/or reduced
picture quality, do not touch the glass portion of the
new lamp.
Tighten the screws fi rmly on the new lamp unit,
taking care not to overtighten.
Replace the lamp cover by re-engaging the two clips;
tighten the screw on the lamp cover.
Replace the front cover by aligning it on the
television and pushing gently until it snaps into place.
Plug the power cord back into the wall outlet and
turn on the power.
3222 625 91951
Hitachi ® is a registered trademark of Hitachi Corporation.
PHILIPS
SALE on Projector Bulbs at www.BulbAmerica.com
take additional 5% Off with coupon code 5PDF