Philips CSP410 User manual

www.philips.com/welcome
Register your product and get support at
CSP410
CSP510
CSP610
CSP6910
EN User manual

1. Important
Safety
Read and understand all instructions before you use the apparatus.•
If damage is caused by failure to follow instructions, the warranty
does not apply.
Use only the supplied mounting hardware for a safe and secure•
installation.
Do not continuously use the speaker system beyond the peak power•
handling capacity.
Keep credit cards, watches, recorded tapes etc. with magnetic coding•
away from the speaker system to prevent damage caused by the
magnets in the speakers.
Clean the apparatus with soft, damp cloth. Never use substances•
such as alcohol, chemicals or household cleaners on the apparatus.
Notice
Environmental information
All unnecessary packaging has been omitted. We have tried to make
the packaging easy to separate into three materials: cardboard (box),
polystyrene foam (buffer) and polyethylene (bags, protective foam sheet.)
Your system consists of materials which can be recycled and reused
if disassembled by a specialized company. Please observe the local
regulations regarding the disposal of packaging materials, exhausted
batteries and old equipment.
Anychangesormodicationsmadetothisdevicethatarenotexpressly
approved by Philips Consumer Lifestyle may void the user’s authority to
operate the equipment.
2009 © Koninklijke Philips Electronics N.V. All rights reserved.
Specicationsaresubjecttochangewithoutnotice.TrademarksarethepropertyofKoninklijke
Philips Electronics N.V. or their respective owners. Philips reserves the right to change products at
any time without being obliged to adjust earlier supplies accordingly.

2.Your car stereo speakers
Congratulationsonyourpurchase,andwelcometoPhilips!Tofully
benetfromthesupportthatPhilipsoffers,registeryourproductat
www.philips.com/welcome.
Introduction
With the speakers, you can enjoy high power music with vivid sound.
What’s in the box
Check and identify the contents of your package:
aSpeakers (x2)
bGrille net + Frame (x2)
cSpeaker wire (x2)
dScrew (x8)
eShrapnel (x8)
3. Installation
A depth of at least 48mm is required to mount
the subwoofer. Measure the depth of the area
where you are to mount the subwoofer, and
ensure that the subwoofer does not obstruct any
other components of the car.
b
e
a
d
c

Option 1: Mount on door (front or rear)
You can mount the speakers on the front/rear door of your car.
Note
•Make sure that nothing obstructs around the mounting location of the door.
A hole for mounting may already be cut out of the inner panel of the door
•
(front or rear). In this case, you need to modify the board only.
Ensure that the speaker terminals, frame or magnet do not interfere with any
•
inner parts, such as the window mechanism in the door (when you open or
close the window), etc. Also ensure that the speaker grille does not touch any
innerttings,suchasthewindowcranks,doorhandles,armrestsetc.
1 Turnoffthecarignitionkey.
If the power is on, the click noise generated by the• connection may damage the speakers.
2Cut out the mounting template from the packing box.
3Paste the template on the location selected for mounting the
speaker.
4Mark the cut-off hole and the 4 bolt holes.
5Cut out the marked area and drill the bolt holes.

6Remove the grille net.
7 Stripthespeakerwiresandconnectthemtotheamplier.
Black wire: connect to left speaker•
Black (white lined): connect to right speaker•
Amplifier
Right White lined White lined
Right
Left
Black
Black
Left
CSP410
Note
•Match the “left”, “right”, “+” and “-” terminals correctly. Revised polarity may
degrade sound quality.
Two4-ohmspeakers,wiredinstereo,presenta4ohmloadtoeachchannel
•
oftheamplier.Mosttwochannelampliersworkwellinthisconguration.
However, if two 4-ohm speakers, wired in parallel to a bridged two -channel
amplier,presenta2-ohmmonoloadtotheamplier.Most2-channel
ampliersdonotsupport2-ohmmonooperation!Amplierdamagemay
result!

8Mount on the speaker as shown below.
9Press and insert the edges of the grille net.
Tip
Thespeakergrillecanbemountedwithoutthegrillenet,
•
if you like.
Option 2: Mount on rear tray
You can also mount the speakers into the surface of the rear tray.
Follow the steps in section “Option 1: Mount in door” to mount
the spkeakers into the rear tray:

4. Product information
Note
Product information is subject to change without•
prior notice.
Model CSP410 CSP510
Speaker type 10cm 2-way
coaxial speaker
13cm, 2-way
coaxial speaker
RMS power (Watts) 30W 35W
Peak music power
(Watts)
150W 180W
Sensitivity (dB/W/m) 88dB 89dB
Frequency response (Hz) 50-30kHz 45-30kHz
Impedance (ohms) 4 ohms 4 ohms
Magnet mass (Oz) 4.4Oz 6.4Oz
Model CSP610 CSP6910
Speaker type 16.5cm, 2-way
coaxial speaker
16x24cm, 3-way
triaxial speaker
RMS power (Watts) 40W 50W
Peak music power
(Watts)
210W 300W
Sensitivity (dB/W/m) 90dB 90dB
Frequency response (Hz) 40-30kHz 28-32kHz
Impedance (ohms) 4 ohms 4 ohms
Magnet mass (Oz) 7.6Oz 12.6Oz

5.Troubleshooting
Tokeepthewarrantyvalid,nevertrytorepairthesystemyourself.
If you encounter problems when using this apparatus, go to the Philips
web site (www.philips.com/welcome). When you contact Philips,
ensure that the apparatus is nearby and the model number and serial
number are available.
Name of the Parts
Hazardous/toxic Substance
Pb, Lead Hg, Mercury Cd, cadmium Chromium 6+ PBB PBDE
Housing O O O O O O
Loudspeakers O O O O O O
PWBs X O O O O O
Accessories (Remote
control & cables) X O O O O O
O: Indicates that this toxic or hazardous substance contained in all of the homogeneous materials for this part is
belowthelimitrequirementinSJ/T11363-2006.
X: Indicates that this toxic or hazardous substance contained in at least one of the homogeneous materials used
forthispartisabovethelimitrequirementinSJ/T11363-2006.
Environmental Protection Use Period
Thislogoreferstotheperiod(10years)duringwhichthetoxicorhazardoussubstancesorelementscontainedinelectronic
information products will not leak or mutate so that the use of these [substances or elements] will not result in any severe
environmental pollution, any bodily injury or damage to any assets.
© 2009 Koninklijke Philips Electronics N.V.
All rights reserved.