Picket House Furnishings CEL100ETE User manual

Assembly Instruction for
END TABLE
CEL100ETE
Caution: Please read instructions thoroughly before unpacking assembly parts.Sharp,exposed staple tips can
cause injury,therefore,for your protection,please remove any exposed staples used in packing.
We recommend that you should assemble this product with the assistance of another person;this will make
assembly easier, and will help to eliminate damage to the product or injury to persons during assembly.
Be sure to check all packing materials carefully for small parts that may have come loose inside the carton
during shipment.
1.
2.
3.
4.
Please do not over tighten screws or bolts.
Please Put all parts on a non-abrasive floor before assembly, and follow the assembly steps to assemble your
newly purchased product correctly and efficiently.
PART LIST
No.
A
B
C
D
PART DESC
TEMPERED GLASS TOP
LEG
BASE
METAL RING
PCEL100ETLEGNT
PCEL100ETBASNT
CODE. Q'TY
1
4
1
1
NO.
1
2
3
4
5
6
HARDWARE LIST
HARDWARE DESC
ALLEN BOLT (5/16"x 50mm)
SPRING WASHER(5/16")
FLAT WASHER (5/16"x 19mm)
ALLEN KEY(M5)
SCREW (Ø8*38mm)
SUCTION CUP
CODE. Q'TY
8
8
PCEL100ETHWNT 8
1
4
PCEL100ETCUPNT 4
NOTES ：Do not fully tighten any bolts until last step.
STEP : 1
TOOLS REQUIRED (NOT PROVIDED)
Phillips Screw Driver
3
2
1
4
C
B
MADE IN VIETNAM PAGE 1 OF 2

Assembly Instruction for
END TABLE
CEL100ETE
STEP : 2 STEP : 3 Red Sticker
A
6
5
D
MADE IN VIETNAM
COMPLETED
PAGE 2 OF 2
WARNING: To avoid serious personal injury:
• Carefully and strictly follow assembly instructions. Improper assembly of furniture can result in
structural failure, instability of the product, or tip-over.
• Monitor and carefully control the assembly components. These include small parts and hardware
that may present a choking hazard to small children. Furniture should be assembled only by
responsible adults and children should not be involved in the assembly process.
• Where provided, wall mounting hardware should always be used as prescribed in these instructions
to anchor furniture to wall. Proper use of the wall mounting hardware can significantly reduce the
potential for furniture tip-over and crushing injuries.