PSEN mag/cs bracket straight
Operating Manual PSEN mag/cs bracket straight
1003894-EN-02 3
Description
The mounting plate PSEN mag/cs bracket straight is used to attach a safety switch or actu-
ator to a strut profile.
The mounting plate can be used with the following products:
}Sensors (safety switch and actuator):
– PSEN 1.1a, PSEN 1.1a/b, PSEN 1.1b, PSEN 1.1p
– PSEN 2.1a, PSEN 2.1a/b, PSEN 2.1b, PSEN 2.1p
– PSEN cs3.1a/b, PSEN cs3.1n, PSEN cs3.1p/M12, PSEN cs3.19n
– PSEN cs4.1a/b, PSEN cs4.1n, PSEN cs4.1p/M12, PSEN 4.1 M12/8-1.5m
– PSEN cs4.2a, PSEN cs4.2n, PSEN cs4.2p/M12
– PSEN cs5.1n, PSEN cs5.1p, PSEN cs5.1 M12/8, PSEN cs5.11 M12/8, PSEN
cs5.13 M12/8 EX
– PSEN cs6.1n, PSEN cs6.1p, PSEN cs6.1 M12/8, PSEN cs6.11 M12/8
– PSEN cs6.2n, PSEN cs6.2p, PSEN cs6.2 M12/8, PSEN cs6.21 M12/8
– PSEN ma1.4, PSEN ma1.4a, PSEN ma1.4n, PSEN ma1.4p
}Strut profiles: 30 mm/40 mm/45 mm/50 mm/60 mm width
Installation
Attachment to strut profile
First of all attach the mounting plate to the strut profile using the corresponding fixing
screws and slot nuts. Use the holes that match the strut profile (see diagram).
INFORMATION
For each mounting plate you will need
– 2x hexagon socket countersunk screws, shaftless, M4x12-8.8 in ac-
cordance with ISO 10642,
– 2x slot nuts M4, matching the strut profile.
These are not supplied with the unit.
