Pinnacle Speakers Powered Subwoofer User manual

Powered Subwoofer
Owner’s Manual
2011 PINNACLE LOUDSPEAKERS
Meijer.com

1
We congratulate and thank you for choosing a PINNACLE®subwoofer. Our subwoofers
exemplify the best in modern audio technology, and are designed to produce remarkable amounts of
deep bass. Please read this manual completely to ensure the best possible performance from your
Home Theater or sound system.
ISOLATION CONES:
If your subwoofer comes with Isolation Cones (feet) be sure to install them into the bottom of
your subwoofer cabinet. They are an important part of the performance of the product and will improve
the bass definition. If your subwoofer is bottom vented, you must install the isolation cones for the
bottom vent to operate properly.
With the cabinet on its side, simply screw the cones into their receptacles on the bottom of the
cabinet. Then, with the cabinet upright, adjust the cones individually as needed to level the cabinet.
PLACEMENT:
Recommended Subwoofer Placement:
a) Within a few inches of the room corner closest to your left or right front speaker (maximum low
bass output);
b) Within a few inches of the wall between your left and right front speakers (strong low bass
output with optimal blending to front speakers);
c) Near any other room corner or wall.
Other locations will provide varying degrees of low bass impact and blending with your front
speakers. We recommend listening to your system, with the subwoofer in different room positions, to
obtain a location with an optimum response.
If your subwoofer has a woofer on both the front & rear of the cabinet, be sure to leave at
least an inch between the rear woofer and your wall.
If you must place your subwoofer near baseboard heaters or forced hot air vents try to leave at
least 3” of clearance for proper ventilation. Do not place your subwoofer outdoors, or in any wet or
excessively damp environment.
Note: If you have an older, non-flat screen TV, please place your subwoofer far enough away
from your TV (approximately 2-3 feet) to avoid any color distortion from being caused by your
subwoofer’s powerful magnet(s). If you experience picture distortion, simply move the subwoofer away
from the TV until the picture becomes distortion free.
We also recommend keeping magnetic media such as audio/videotapes and computer disks at
least 2-3 feet away from your subwoofer to prevent damaging them.
Meijer.com

2
CONNECTIONS:
Complete all wire connections in your Home Theater / sound system before plugging in your
subwoofer or turning on your receiver (amplifier).
Connecting Your Subwoofer:
To connect your subwoofer your receiver must have a dedicated "subwoofer output" jack
(sometimes called Sub Out, Low Pass or LFE). Simply connect your subwoofer using a standard
(coaxially shielded) RCA cable (the same kind of audio cable used to connect your CD, tape deck, etc.)
from your receiver’s subwoofer output to the input on the subwoofer. Then, wire your left and right front
speakers directly to your receiver’s speaker outputs. Please refer to the wiring diagram above for
further clarification. Note: Do not connect your subwoofer to the tape loop outputs from your receiver
as they will overdrive its circuitry!
Meijer.com

3
POWER-UP AND TONE CONTROL ADJUSTMENTS:
•With the VOLUME control at minimum (fully counter-clockwise) plug your subwoofer’s power cord
into any ordinary wall outlet. The red power indicator LED will stay on as long as the subwoofer is
plugged-in. If for any reason you do not want your subwoofer on, simply unplug it.
•Please ensure that your receiver’s loudness control is off and that the bass tone control is in its
middle (flat or no boost) position. Now play some music with ample bass content. (The following
setup routine is best accomplished with one person seated in a normal listening position directing
another to adjust the controls for the best sound.)
•Adjust the VOLUME level on the subwoofer’s control panel so that the output level of the subwoofer
is satisfactory (relative to your front speakers). If either of your front speakers or subwoofer are not
functioning properly, please refer to the Troubleshooting section toward the end of this manual.
•Adjust the FREQUENCY ADJUST knob and determine what position sounds best. This feature
controls the output level of the mid and upper bass frequencies. Please note that if you have
hooked up your subwoofer to a Dolby Digital or DTS receiver via its LFE jack, due to the low pass
filter already in the receiver, the subwoofer's frequency adjust control would be best left at the
highest frequency (fully clockwise).
•Adjust the PHASE switch on the subwoofer’s control panel to determine which position sounds the
most natural and powerful. The difference should be most audible in the mid-bass. If you cannot
detect a difference, leave the PHASE switch in the + (in-phase) position.
•The best VOLUME level, FREQUENCY ADJUST and PHASE switch positions will mostly be
determined by your room acoustics, the mid and upper bass frequency response characteristics of
your front speakers, and your personal preferences. The source material will also play a significant
role as its bass level and qualities may vary considerably.
•After your initial adjustments you may want to go back and “tweak” these controls. Their effects are
acoustically interrelated. Re-adjusting them may be necessary to obtain optimal performance.
Generally, once you are satisfied with your subwoofer's settings, you can use your receiver’s tone,
equalizer, volume and subwoofer output level controls to optimize your whole system’s
performance.
Meijer.com

4
VERY IMPORTANT!
•If you have a Dolby Pro-Logic Home Theater system, make sure that your receiver’s center
channel mode is in the NORMAL position. This will ensure that all low bass information is sent
to your subwoofer.
•If you have a Dolby Digital or DTS Home Theater system, make sure that you have correctly
configured your receiver's Bass Management System so that all of your speakers are
properly categorized as either SMALL or LARGE. This will ensure that all appropriate low
bass information is sent to your subwoofer. As a general rule, a speaker with an 8" or
greater diameter woofer may be considered LARGE. Conversely, a speaker with a woofer less
than 8" in diameter may be considered SMALL. Please note that the bass output of a dual
woofer speaker could be comparable to that of a larger single woofer speaker. Example: A
dual 6.5" woofer system would generally be considered LARGE since its woofer area
approximates that of a single 10" woofer system.
•With high volume levels of certain types of signals, your subwoofer may be audibly strained.
If you hear the subwoofer “breaking-up” or distorting, turn down the volume level.
•If you have any problems or questions, please contact your PINNACLE®dealer for further
assistance.
Meijer.com

5
TROUBLESHOOTING:
No Sound only from Subwoofer -Check the subwoofer's volume setting and all connections. If your
receiver has a subwoofer on/off or variable subwoofer output level control, ensure that the subwoofer
option it is turned on and that the output level is at maximum. Ensure that the center channel mode on
the receiver is in the NORMAL or SMALL position. Make sure that the subwoofer's RCA cable is
connected to the receiver's subwoofer output and not the subwoofer input jack. In the event that the
problem persists, refer to the TO OBTAIN SERVICE section of your warranty at the end of this manual.
No Sound only from Left and Right Front Speakers -Check all connections. Ensure that your receiver’s
speaker channel A or B is switched on.
Too Little Bass -Check: subwoofer volume/frequency/phase control positions; receiver tone controls;
program material; ensure that the center channel mode on the receiver is in the NORMAL or SMALL
position. If your receiver has a variable subwoofer output level control, ensure that the output level is at
maximum. Try moving the subwoofer further into a corner or towards the wall.
Too Much Bass -Check: subwoofer volume/frequency/phase control positions; receiver bass/loudness
controls; program material; move subwoofer further out of corner or away from wall.
Hum:Check for faulty phono connecting cable. Try to separate phono cables from power cords (they
can induce hum into the system). If that doesn't work we recommend you turn off your subwoofer when
it is not in use. This is most easily accomplished by either connecting its powercord to a switched
power outlet on the back of your receiver (if it has them) or by using a Remote Controlled Switched
Outlet like Radio Shack part #61-2667.
Meijer.com

6
LIMITED WARRANTY:
What Is Covered
Your Pinnacle®subwoofer features a limited warranty as follows. The subwoofer driver and all
assembly and construction aspects are covered by this warranty for a period of seven (7) years from
the date of original purchase. Your subwoofer amplifier is covered by this warranty for a period of
two (2) year from the date of original purchase. The warranty covers all necessary parts and labor to
return the subwoofer to proper working order. Cabinet surfaces, grille assembly, and other exterior
parts subject to normal wear and tear are not covered except where an inherent structural defect
becomes evident.
Parts replacement and labor will be performed at the discretion of Pinnacle Loudspeakers and will
be provided free of charge unless (in the opinion of our service department, service representatives,
or engineering department) the system has failed due to abuse or negligent operation.
What Is Not Covered
This warranty will be void and no free services performed if we or any party acting as our agent
determines that the system has had any of its elements (amplifier, woofer, etc.) removed or
tampered with in any way whatsoever. Furthermore, if your subwoofer is not found to be defective a
service charge will be levied. In either case the minimum charge will be $30.00. An additional
charge will be applicable for same day service where possible and this charge will always be in effect
even if the actual parts and labor are covered by this warranty. Pinnacle Loudspeakers reserves the
right to make the final determination of whether or not the system has been damaged by abuse or
negligent operation.
To Obtain Service
(516) 576-9052. If you ship your subwoofer you are responsible for packing and shipping insurance.
The freight must be prepaid. We will, however, pay return freight charges on any returned
subwoofer that qualifies for in-warranty service. Sorry, we cannot accept any collect freight charges.
You must include a note, attached to the unit, with your name, phone number or email address, and
return shipping address (no Post Office boxes), indicating the nature of the problem you are
experiencing. For warranty service you must also include a copy of your sales receipt. YOU MUST
FIRST CONTACT US FOR THE CUSTOMER SERVICE SHIPPING ADDRESS IN YOUR AREA IF
YOUR DEALER IS NOT EQUIPPED FOR THIS SERVICE. Please be sure to pack any items you
ship us carefully since we cannot be held responsible for damages incurred during shipping.
This warranty may be transferred to a subsequent owner.
SAVE YOUR ORIGINAL SHIPPING CARTON AND PACKING MATERIALS, AS WELL AS THIS
WARRANTY AND YOUR SALES RECEIPT. YOU WILL NEED THEM TO OBTAIN SERVICE
UNDER THE PROVISIONS OF THIS LIMITED WARRANTY.
Meijer.com

415 Oser Ave, Suite M
Hauppauge, NY 11788
www.pinnaclespeakers.com
PR MAN Q1 REV0211
Meijer.com
Table of contents
Other Pinnacle Speakers Subwoofer manuals