Pixlip 400097 User manual

400097 400097
Aufbauanleitung
User manual
MONITORSEILHALTERUNG
MONITOR CABLE MOUNT
www.pixlip.com

2
TIPSTIPS & SAFETY
[email protected]
SUPPORT REQUEST ASSEMBLY ONLY
WITH CLEAN
HANDS
TWO PEOPLE ARE
REQUIRED FOR THE
ASSEMBLY.
Before the installation and use of the appli-
ance, carefully read the supplied instructi-
ons. The manufacturer is not responsible for
any injuries or damages that are the result
of incorrect installation or usage. Always
keep the instructions in a safe and accessible
location for future reference. Assembly and
installation should only be carried out by
trained specialist personnel.
Please only use the delivered devices. Faulty
wiring can cause damage. Do not install or
use a damaged appliance.
Please consider that unauthorized modi-
cations on the device are forbidden due to
safety reasons! Disconnect your system from
the power supply before starting installation
or maintenance work. Please make sure that
it cannot be switched on again accidentally.
Do not expose the device to direct sunlight,
moisture, extreme heat, hot light or strong
magnetic elds. Keep proper ventilation
around the unit and do not stack any object
on it. Never operate the device without
casing hood, with closed vent slots, at high
temperatures, at high air moisture.
Connect the system only to an easily accessi-
ble socket located near the installation site.
Always use a correctly installed shockproof
socket. To avoid tripping hazards, do not use
extension cables and don’t use multi-plug
adapters.
Output current and output wattage must not
exceed the rated values on the specications.
Do not stare directly into the LEDs. Do not
use devices which can strongly focus light for
viewing the light beam. Do not use aggressi-
ve chemicals or abrasives for cleaning.

3
COMPONENTS
Montagebolzen
Mounting Bolt
Schrauben Set
Screw Set
Wandscheiben
Wall Disks
Abstandshalter
Spacers
Vertikalclipse
Vertikal Clips
Monitorseilhalterung l Monitor Cable Mount
4 × Montagebolzen l Mounting Bolt
1 × Schrauben Set l Screw Set
2 × Wandscheiben l Wall Disks
2 × Abstandshalter l Spacers
1 × Vertikalclipse l Vertical Clips

4
15 -
25 cm

5

6
20 - 30 cm

7

8

9
Cut holes in the textile at the points
where the mounting bolts are
visible in order to attach the
other holders later.

10

11
Cut a hole in the textile at that point
where the cable connection of
the TV must be placed.

12
Remove one corner of
the print to lay the
cable connection
for the TV.

13

14

15

16

17

18

19

© 2019
PIXLIP GmbH
Raiffeisenstraße 17
40764 Langenfeld
Germany
[email protected]
www.pixlip.com
www.pixlipgo.com
MONITORSEILHALTERUNG lMONITOR CABLE MOUNT
AUFBAUANLEITUNG
USER MANUAL