2 3
1. If you have an X-stream
counter current unit place it
in the pre-cut whole. It may
be necessary to even out
the fitment by packing the
bottom of the unit with a thin
piece of wood or similar,
from the outside of the pool,
remove the grab bar and facia
plate from the unit and keep
all parts safe.
2. Fix the X-stream unit
in place using the fixings
supplied with the unit.
3. Remove the nozzles from
the counter current unit and
keep all the parts in order
somewhere safe. Carefully
stick one of the gaskets to
the unit, ensuring the holes
for the machined screws
match up. Then partially
insert a screw in each corner.
Installing the X-Stream Counter Current System
4. X-Stream Duo model
only; If you have an X-Stream
Duo pool you will need to fit
the extra 63mm suction point
using the screws Provided
with the fitting, again keep
all the other parts safe until
required.
5. X-Stream Duo model
only; Apply one of the self-
adhesive gaskets carefully
to the suction point, then
partially insert two screws
with the cross hairs pointing
North, South, East and West
as the image shows below.
6. Image shows gaskets and
screws in place on skimmer
X-Stream unit, inlet and
low-level suction.
7. Pay particular attention to
pressing the foam underlay
firmly into the corners and
under the liner-lock of the
pool. Avoid getting adhesive
on any fittings such as the
inlets or skimmer.
Trim around the perimeter of
the pool by running a sharp
pair of scissors directly under
the liner lock. Cut the foam
away neatly around any pool
fittings.
8. Before cutting in the
fittings on the liner Plumb up
any filtration/counter current
pipework.
Installing the X-Stream Counter Current System – Liner Cutting Instructions
9. Again, before you start
cutting in fittings for the
X-stream unit the water level
should be approximately
50mm below the screw heads
which should be visible from
behind the liner. Carefully
expose the screw heads and
four threaded lugs using the
same method as when cutting
in the inlets. Start with a small
cross incision in the centre of
the screw keeping it as small
as possible but just enough,
to stretch the liner over the
screw/threaded lug.
10. Carefully attach the
gasket to the faceplate
ensuring all the holes line up.
Then you can undo one of the
corner screws and thread it
back through the hole. This
will help you locate the other
three corners. Once you have
all 4 screws in place tighten
them by hand with a hand-
held screwdriver.
11. Now you have the face
plate in position, use a sharp
pointy object like a screw
to make a small hole for
each machined screw to go
through, each hole on the
face plate.
