Playcore DERO Cycle Dock User manual

©2021
Cycle Dock™ Setbacks
36" 60"
36"
STREET
STREET
WALL
WALL
36"

©2021
InstallationCycle Dock™
RECOMMENDED BASE MATERIAL
Solid concrete is the best base material for installation. To ensure the proper anchors
are shipped with your rack, ask your Dero representative which anchor is appropriate
for your application. Be sure nothing is underneath the base material that could be
damaged by drilling.
TOOLS NEEDED
Tape Measure
Marker or Pencil
Masonry Drill Bit 3/8”
Drill (Hammer drill recommended)
Hammer
Wrench 9/16”
Level
Drill 3/8” diameter holes 3” deep into surface. Make sure the
holes are at least 3” away from any cracks in the base material.
Place the rack in the desired location. Use a marker or pencil to
outline the holes of the flange onto the base material.
Place rack (and washers to level rack if necessary) over holes.
1
3
2
4
Ø 3/8”
9/16”
3”
Thread nuts onto anchors, leaving approximately 1/4” of the
anchor protruding, and tap into surface. Tighten nuts down to
secure rack.

©2021
Installation Footing DiagramsCycle Dock™
(or standard 4” sidewalk slab)
48”
10”
18”
SURFACE MOUNT