2
3
1
2
3
Marker tray
Side covers
(3) Attach the marker tray to the Copyboard.
햲Insert the side covers into both ends of the marker
tray.
•Note that there are left and right type side covers.
햳Temporarily fasten the three M4 x 8 screws into the
Copyboard (leaving about 3 mm)
•Use the supplied screwdriver.
햴Insert the marker tray over the 3 screws that have
been temporarily fastened, and then tighten securely.
•Please insert the marker tray as far as they will
go.
M4 x 8 screws
1
2
3
3
3
Cap
Extension frame
Frame
Cap
Cap
Foot
Spring
washer
Foot washer
M8 hexagonal wrench
M8 x 50 hexagonal
socket head screw
T-shaped leg
Crossbar
Crossbar
Flat washer
M5 hexagonal
socket head
screw
M5 hexagonal
wrench
(1) Assemble the T-shaped legs (two).
햲Mount the foot using washers, spring wash-
ers and M8 x 50 hexagonal socket head
screws.
햳Make sure of the orientation of the extension frame
and the frame end looking at the marks, then insert
all the way. (Note that it will no longer be possible to
remove the extension frame when the mark sur-
face has been inserted in the opposite orientation.)
Notice:
•Mounting the extension frame makes for a height
of 1700 mm off the floor (compared to 1465 mm
without the extension frame). Use this to adjust
the height.
•For the assembly procedure when not mounting
the extension frames, see step (1) under “Assem-
bling the stand and mounting the copyboard ver-
tically”.
햴Fit the caps on the top of the frame and feet.
(2) Mount the two crossbars onto the T-shaped
legs assembled in (1) above.
Mount them using the M5 hexagonal socket head
screws and flat washers.
Temporarily fasten the screws using the included M5
hexagonal wrench, then fasten them securely once
both the upper and lower crossbars have been
mounted.
* Assemble in a flat place.
