TEMPERATURE 888
ECO MAX
MAX
ECO ON/OFF
BOX
P LAR
FILLING
Do not put hot food items into the refrigerator.
Place the products in such a way as to avoid
them hitting against each other or breaking
because of the movement of the vehicle.
Make sure that the lid is always well closed and
open it for as short a time as possible.
DEFROSTING
Defrosting is needed when the layer of frost is
thicker than 4 mm.
To carry out this operation, turn off the
refrigerator. Do not use sharp or cutting tools
to remove the layer of frost or ice. Wait until
complete unfreezing and then turn on again.
MAINTENANCE
Before carrying out any
maintenance operation on the
refrigerator, take the power cable
out of its socket.
CLEANING
Clean the inside of the refrigeraor regularly,
using sodium bicarbonate in lukewarm water.
Never use abravise products, detergent or
soap. After washing, rinse out with clean water
and dry carefully. When not using the device,
clean and dry it inside carefully in order to
prevent mildew and bad smells.
SUGGESTIONS
Should the device fail to work or work badly, before referring to our after-sales service,
make sure that:
a) the feeding voltage is not missing;
b) the voltage is the same as the one shown on the plate;
c) the connections and the polarities are right;
d) the airing grids are not covered over;
e) the refrigerator unit is not near any heat source;
f) the fuse of the feeding line is not blown.
The power supply cable must be replaced only by qualifi ed technical personnel and
in any case by an after sales service authorised by the Manufacturer.
USEFUL ADVICE
1) Use the product in MAX mode in these cases:
- use of the product as refrigerator and/or freezer with high ambient temperature;
- when the suitable temperature need to be achieved in few time.
2) Use the product in ECO mode in these cases:
- use of the product as refrigerator and, in particular, with low ambient temperature;
- when the vehicle is parked for long time (with engine switched off)
!
!
- Plug in the DC or AC power. Press the
button `ON/OFF` to run the refrigerator.
The LED display on the control panel
would be lighted and the interior
temperature would be displayed.
- Press the button and to adjust
the temperature. Press the button to
increase while the button to decrease
the temperature. When press the above
two buttons at the same time, it would switch the display between °C and °F.
- Press the ECO key to enter the “ECONOMY” operating mode: the ECO light turns on and the compressor
runs at minimum speed by keeping a fresh temperature inside the refrigerator. By pressing the ECO
key again, the light turns off and the refrigerator enters in MAX mode (mode (maximum number of
compressor turns). MAX light will be switched on until having acheved the temperature set.
USE
