Poly G10 Series Manual

3725-30775-001B
Poly G10 Series, Poly G40 Series, and Poly G80 Series PC Mounting Kit
SETUP SHEET
See the Regulatory Notices guide for all regulatory and safety guidance prior to configuration.
Avant de procéder à la configuration, veuillez consulter les Avis de réglementation, afin de prendre connaissance des recommandations en matière de sécurité et de réglementation.
2
Mount the plate to the wall using four M4 ×
35 expansion screws, flat washers, and
plastic wall anchors.
3
Attach the four mounting screws using the
outer M4 riveting studs.
4
Slide the PSU into the PSU holder.
(4) M4 x 35 Expansion Screw
(4) Flat Washer
(4) Plastic Wall Anchor
(4) Mounting Screw
UP
UP
1
Drill four 6 mm holes in the wall, 200 mm apart, to a depth of
40 mm.
6 mm 200 mm
200 mm
Tools Needed:
6 mm
×4
Depth = 40 mm
support.polycom.com/video

5
Attach the PSU to the plate by inserting the top two screws into the
two keyholes and sliding to the left to lock in place.
6
Attach two thumb screws at the bottom of the PSU holder. Wrap the cable
wrap around the power cable.
7
Slide the PC into the PC holder and attach two thumb screws.
(2) M3.5 × 6 Thumb Screw
UP
UP
8
Attach the PC to the plate by sliding the PC holder keyholes
onto the four mounting screws.

© 2020 Plantronics, Inc. All rights reserved. Poly, the propeller design, and the Poly logo are trademarks of Plantronics, Inc. The Bluetooth trademark is owned by Bluetooth SIG,
I
nc. and any use of the mark by Plantronics, Inc. is under license. All other trademarks are the property of their respective owners.
10
Attach the cover to the wall plate by inserting the four bolts into the top of the four corner keyhole slots and sliding them down to lock in place.
9
Connect the cables to the PC. Attach the cable retainers by inserting the two circular ends of each cable retainer into the top of the keyhole
slots and sliding them down to lock in place.