Polycom RealPresence Group 700 system Instruction Manual

www.polycom.com
© 2014, Polycom, Inc. All rights reserved. POLYCOM® and the names and marks associated with Polycom’s products are trademarks and/or service marks of
Polycom, Inc. and are registered and/or common law marks in the United States and various other countries. No portion hereof may be reproduced
or transmitted in any form or by any means, for any purpose other than the recipient’s personal use, without the express written permission of Polycom.
1725-09099-001/A
Installing a Polycom®RealPresence®
Group 700 System in the Polycom®
RealPresence® Group Series Media Center
For more information about the components of the RealPresence Group Series Media Center,
refer to the documentation at
http://support.polycom.com/PolycomService/support/us/support/video/group_series/group_packaged_solutions.html.
1
This supplement describes how to install a Polycom®RealPresence®Group 700 system in the Polycom®
RealPresence® Group Series Media Center. Follow the instructions in Setting Up the Polycom RealPresence Group
Series Media Center, 1725-08510-00X, and use this supplement to replace the steps to install the system.
Attach the Group 700 system to the tray using
three of the four screws, removed in step 19a,
on each side of the Group 700 system.
19a Remove the four screws from both sides of the
Group 700 system.
Position the Group 700 system in the tray.
19b
19c

Installing a Polycom® RealPresence® Group 700 System in the
Polycom® RealPresence® Group Series Media Center 2
After the cables are installed, pivot the Group
700 system to an upright position.
Attach the upper tray ears to the upper rack nut
fasteners using two screws on each side.
Attach the mounting ear to the lower right screw
location using the washer and shoulder screw.
Repeat on the other side. Note that the design of
the mounting ear shown below has changed.
19d
19e 19f Remove the two screws temporarily installed
at the top. Pivot the codec down to access
the I/O and to cable the unit. Refer to Setting Up
the Polycom RealPresence Group 700 System
for cabling details.
19g 19h
Attach the top left and top right mounting tabs
temporarily in place using one screw on each
side. The lower pivot mounts will fall into position
over the appropriate rack clip locations. Secure
with two screws on each side.
19e Install four clip-on rack nut fasteners in holes 7
and 9 from the top of the upper set of holes and
in holes 2 and 4 from the top of the lower set of
holes, on the left vertical support. Repeat with the
right vertical support.