Philips DVP5900/37B Operating manual

QUICK USE GUIDE DVP5900
A what’s in the box helpful hints
B connect TV
ADVD Player
PREVIEW
PREVIEW
MUTE
MUTE
BRemote Control
includes 2x AA batteries
CVideo cable
(yellow)
DAudio cable
(red/white)
You only need to make one video connection to your TV
in order to view DVD playback.
If your TV has
this video input jack(s)
1
2
Use this
video cable(s)
VIDEO
IN
Component Video
not supplied
supplied
If yourTV has only a single Antenna In jack,
you will need an accessory RF modulator. The RF
modulator converts the video from the DVD player
so it can play through theTV’s Antenna connector. Refer
to your owner’s manual for proper connection.
ANTENNA IN
DIGITAL
COAXIAL
OUT
CVBS
VIDEO OUT
YCr/Pr
Cb/Pb
HDMI
AUDIO
OUT
AUDIO
IN V (Pr/Cr)
U (Pb/Cb)
Y
S-VIDEO
IN
VIDEO IN
COMPONENT
VIDEO IN
AUDIO
OUT
V(Pr/Cr)
U(Pb/Cb)
Y
S-VIDEO
IN
VIDEOIN
COMPONENT
VIDEOIN
Connect the mains
cord to the power
supply
3
Connect the DVD
Player VIDEO OUT to
VIDEO IN on the TV
1
Connect the DVD
Player AUDIO
OUT to AUDIO IN
on the TV
2
Note: For connecting to a Progressive Scan TV, refer to the user manual for proper
connections and detailed set up.
12NC No. 3139 246 18931

PREVIEW
PREVIEW
MUTE
MUTE
1
3
2
IR
LABEL
D Troubleshooting
C play a disc
GET PICTURE
•Check the connection of the DVD system
to TV is in place (see 2 Connect TV).
•Check the AV mode on TV. It may be
called FRONT,A/V IN, or VIDEO. Choose
the different modes usingTV remote
control.
•Or, use the TV remote control to select
Channel 1 on TV, then press Channel down
button until you get the picture.
•See your TV manual for more details.
For more troubleshooting tips, see the user manual
NEEDS HELP? Visit our website www.usasupport.philips.com
1Turn on the TV and set it to the correctVideo In channel.
2Press STANDBY-ON on the DVD Player.
3Press OPEN/CLOSE /on the DVD Player and load a disc.
Press OPEN/CLOSE /again to close the disc tray.
4Playback will start automatically. If not press PLAY B.
5To stop playback, press STOP 9.
REGION CODES
1ALL
Problem Tips
No picture –Refer to your TV’s manual for correctVideo In channel
selection. Change the TV channel until you see the DVD
screen.
–Check if the TV is switched on.
–If the progressive scan feature is activated but the
connected TV does not support progressive signals or the
cables are not connected accordingly, see page 19 for
proper progressive scan set up or deactivate the
progressive scan feature as below:
1) Press OPEN CLOSE 0on the DVD system to open the
disc tray.
2) Press 2followed by AUDIO the remote control.
No HDMI output –Check the video output is HDMI enabled.
–Check the connection between the TV and the HDMI jack
of DVD player.
–See if the TV supports this 480p/576p/720p/1080i DVD
player.