Switching the double cooking area
The control (key 3) or (key 12) can be used to activate 2 heating elements with a double cooking area and
one of them with triple area, with 2 sensors to activate or cancel it. Each cooking area has an associated
LED (Led 4 and 13). The selection of the heating element associated with the second cooking area is
made in the factory through the configuration software.
Touch the double area selector to select/deselect the double cooking area. If one heating-element has 1
double and 1 triple areas the product will be:
1st touch: the double area is selected
2nd touch: the triple area is selected
3rd touch: double and triple areas are not selected.
When the double cooking area is selected the associated LED (Led 4 or 13) turns on, although its heating
element has not been activated.
Activating the heat-up function
When cooking level 9 is selected (this function can only be operated from this level) touching the (+) (key
1) sensor, the decimal point on the display (5) blinks for 10 seconds, during which the desired power level
mustbeselected(between1and8).Afterthistimethereisasoundsignal,andthedecimalpointremains
fixed, indicating the heat-up function is ON. Should the selected level be 0 or 9, the heat-up function is
cancelled.
With the heat-up function activated, by touching the (+) sensor the duration of this function extends to the
new power value selected; if the power is 9, the heat-up function is cancelled. When the heat-up function
is finished, there is a sound signal, the decimal point of the display goes out and the element remains at
the chosen power level.
Cancelling the heat-up function
Touch the (-) (key 1) sensor while the heat-up function is ON to cancel it. The cooking level goes down.
When the heat-up function is cancelled, there is a sound signal and the decimal point on the display
goesout.Ablinking“H”willappearwiththecookinglevel0,whenthetemperatureoftheheatingelement
reaches 65°C. It appears fixed if the touch control is switched off.
Setting the Key lock function
Keep the Key Lock (Key 10) sensor pressed to activate/cancel the keyboard locking function. If the LED
(11) associated with the Key Lock sensor is on, the keyboard is locked.
The locking function can be activated when the cooking levels are activated or when the cook top is off.
If the cook top is on, The Key Lock function locks all the sensors except the On/Off (Key 6) general sensor
and the key lock sensor.
When the cook top is turned off, the Key Lock function blocks all the sensors, including the general On/Off
switch, except the key lock sensor.
Cancellation of the Key Lock function
If the keyboard is locked (the LED 11) associated with the Key Lock (Key 10) sensor is on, keep the Key
Lock sensor pressed for 1 second to cancel the locking function and the indicator light will go out.
Residual heat indicator
While the temperature on the cook top surface is above 65°C, this condition will be shown in the
associateddisplay,bymeansofan“H”.
Ifthecooktopisswitchedoff,residualheatisshownbyastatic“H”inthedisplay.Ifthecooktopison,
butthepowerlevelis0,theassociateddisplaywillshowalternately“H”and“0”.
To generate a temperature above 65°C a heating element has to be in operation for a certain time, which
depends on the selected power level. Once this time is passed, the residual heat warming will come into
operation when the element is switched off.
If the minimum time needed to exceed 65°C is over, the length of time the residual heat indicator remains
in operation is a function of the time the element has remained turned on at a certain power level.
