POSSWAY V4 PRO User manual

USER MANUAL PRO
V4
WWW.POSSWAY.COM

THERE IS A RISK OF SERIOUS INJURY
Whenever you ride a board, you risk death or serious injury from loss of control, collision, and falls. To
ride safely, you must read and follow the instructions and warnings in the manual.
Always wear a helmat when riding. Avoid water, wet surfaces, slippery / uneven surfaces, steep hills,
traffic, cracks, tracks, gravel, rocks, or any obstacles that could cause a loss of traction and cause a
fall. Avoid night riding, areas with poor visibility, and small spaces.
This board has a regenerative brake function. Braking downhill on a full battery can cause a board
shutdown. To avoid this situation please ride on flat or uphill roads to reduce the battery energy before
attempting a downhill.
Warning: Do not ride on side-hills or on an incline of more than 10 degress. Do not ride at speed
which you would not safely control the board. In case of wireless interface or battery error, you may
need to rely on skating techniques like foot braking of sliding to stop.
WARNING: AVOID WATER!
WARNING: RISK OF ELECTRONIC SHOCK!
Your board is not completely waterproof, you can easily go through the puddles but don’t
soak the board in the water. Water damage is not covered under the warranty.
Do not open or tamper with electronics housing without Possway’s guidance, which also
voids the warranty.
READ BEFORE RIDING

Please take some time to learn it and read this manual carefully. Especially safety, we hope
you will like this product and have a lot of fun from it in the future.
THANK YOU FOR BUYING OUR ELECTRIC SKATEBOARD
PROTECT
STANCE
· Always wear a helmet.
· Find an open, flat area with clean pavement for your first ride.
· Read the warning on the skateboard and at the beginning of this manual.
· Other protective equipment is highly recommended.
· Move the throttle wheel in small increments.
· Keep a wide stance on the board.
· Keep a low center of gravity.
· Lean forward when accelerating.
· Lean backward when braking.
Follow these tips to ensure a safe riding experience:

PARTS DIAGRAM
8 Layers Maple
4000mAh 29.4V
Lithium Battery
2.5 Hrs
83mm Hub Motor
400W*2
PU
83*51mm
15-20m
2.4G
40 min
15%
Size
Material
Power
Type
Charging time
Type
Capacity
Material
Max speed
Medium speed
Mileage
Capability
Entire
board
Board
Battery
Motor
Wheel
Remote
Climbing
Low speed
Charge time
Grade
Frequency
Distance
0-7km/h / 0-4mph
0-15km/h / 9mph Max load
Size
N.W. 6.4kg / 14lb
100kg / 220lb
900*230*125mm
13km / 8mph*
0-38km/h / 23mph *
Max speed 0-38km/h / 23mph*
(Faster Acceleration)
Mileage data was tested by a 60kg/132lb rider at M
mode on a flat road.Maxspeed data was tested by
a 60kg/132lb rider on a flat road.

PARTS DIAGRAM
Drive Truck Kit
Deck
Power Button
Front Truck
Battery Case
Charge Port

SwitchRide ModePower On
Accelerate
18
RM
ODO : 00163 KM
30 I
KM/H
Max: 0 KM/H
FW MI+ B-MI+
BO
Brake
Charging
Accelerate
Brake
QUICK START GUIDE
If you're a beginner, please roll the throttle wheel forward gently to start with a slow
speed to avoid falling.

POWER ON / OFF
Auto Power ON
Auto Power OFF
1s
10 Mins
Push the skateboard forward and after a beep, the
skateboard will turn on automatically.
When the skateboard is stationary for 10 minutes,
the power will be turned off automatically.
POWER ON/OFF THE BOARD
Press the power button for 1 second.
A
B

REMOTE CONTROL
Accelerate
Power Button
Function Key
USB-C Charge Port
Hold to Turn on/off
Click to confirm options
Display
Back/Forth
Speed
Top Speed
Speed Mode Brake Mode
Cumulate Mileage
Single Mileage
Remote Control Battery Board Battery
18
RM
ODO : 00163 KM
30 I
KM/H
Max: 31 KM/H
FW MI+ B-MI+
BO
28
RM
ODO : 00163 KM
30 I
KM/H
Max: 0 KM/H
FW MI+ B-MI+
BO
Brake
Charging
Throttle Wheel

MARCHING DIRECTION
18
RM
ODO : 00163 KM
30 I
KM/H
Max: 0 KM/H
FW MI+ B-MI+
BO
18
RM
ODO : 00163 KM
30 I
KM/H
Max: 0 KM/H
BW MI+ B-MI+
BO
Accelerate
18
RM
ODO : 00163 KM
30 I
KM/H
Max: 0 KM/H
FW MI+ B-MI+
BO
Brake
Charging
Double-click to switch marching direction.
Do not switch directions while riding to
avoid falling.
FW: Forward
BW: Backward

SWITCHRIDE MODE
LO: 0-7km/h (4 mph)
HI: 0-38km/h (23 mph)
MI: 0-15km/h (9mph)
Click the button  to switchRide Modeoptions.
RIDE MODE
7
RM
ODO : 00163 KM
30 I
KM/H
Max: 0 KM/H
FW
Lo B-MI+
BO
38
RM
ODO : 00163 KM
30 I
KM/H
Max: 0 KM/H
FW
HI B-MI+
BO
15
RM
ODO : 00163 KM
30 I
KM/H
Max: 0 KM/H
FW
MI B-MI+
BO
Accelerate
28
RM
ODO : 00163 KM
30 I
KM/H
Max: 0 KM/H
FW MI+ B-MI+
BO
Brake
Charging
PRO: 0-38km/h (23mph)
(Faster acceleration)
38
RM
ODO : 00163 KM
30 I
KM/H
Max: 0 KM/H
FW
PRO B-MI+
BO

B-LO
B-MI
B-HI
B-PRO
10
RM
ODO : 00163 KM
30 I
KM/H
Max: 0 KM/H
FW Lo B-MI
BO
Accelerate
18
RM
ODO : 00163 KM
30 I
KM/H
Max: 0 KM/H
FW MI+ B-MI+
BO
Brake
Charging
Pull the throttle wheel back on the remote
control and do not release it. At the same
time, short press the to switch the three
gears of the braking strength.
ADJUST THE BRAKE STRENGTH

ADJUST SPEED UNIT
THUMBNHEEI:OK
UMIT:KM/H
WHEEI SPEED:48
FREQUECY:2402
12
RM
ODO : 00163 KM
30 I
MPH
Max: 0 MPH
BW MI+ B-MI+
BO
Accelerate
Brake
Charging
① Turn off the remote.
② Press the button
and button to enter
setting mode.
③ Roll the throttle wheel
and adjust the speed unit.
④ Press power button to save settings.
THUMBNHEEI:OK
UMIT:KM/H
WHEEI SPEED:48
FREQUECY:2402

SET CRUISE CONTROL
Accelerate
18
RM
ODO : 00163 KM
30 I
KM/H
Max: 0 KM/H
FW MI+ B-MI+
BO
Brake
Charging
18
RM
ODO : 00163 KM
30 I
KM/H
Max: 0 KM/H
FW MI+ B-MI
BO
① Accelerate to the speed you want.
② Short press the Power button to display
CRU, and enter Cruise Control.
③ Push to accelerate, brake, or press the Power
button again to exit Cruise Control.
CRU

PAIR INSTRUCTION
The board and the remote are already paired for sale, if you want to change the drive motors or other settings,
follow the steps below to do the re-connecting.
Accelerate
28
RM
ODO : 00163 KM
30 I
KM/H
Max: 0 KM/H
FW MI+ B-MI+
BO
Brake
Charging
① Press the power button of the board to turn it on.
③ Turn on the remote control .
④ Click the power button and button at the
same time, the connection is successful after a beep.
② Long press the board power button for 5-7 seconds,
after a beep, the signal light flashes to enter the
pairing mode.
The remote control and
skateboard signal light
flashes, and the pairing is
successful.
Signal Signal light

CHARGE THE BOARD
2.5hrs/2A
WARNING: Never leave board
unattended while charging.
After fully charged, the skateboard
indicator light changes from
flashing to solid red.
Please don't charge
the board with a
charger with output
amperage over 2A.

SAFETY INSTRUCTIONS
Wear shoes: Flipflops or similar loose footwear are not suitable for riding wear.
Please observe your local traffic laws and regulations.
Keep fingers, hairs, and clothing away from motors, wheels and moving parts.
The skateboard is designed for rider over 10 years old and above.
A skateboard only can be ridden by one rider each time. The maximum load of the board is
100kg. Exceeding this weight will compromise the structural integrity of the skateboard, as
well as remote and function, and may cause board damage, losing control, etc.
The board is designed to drive on flat and paved surfaces. Avoid driving on sand, gravel,mud,
rugged or open ground. Do not drive on slippery ground, such as snow, ice or wet ground.
10+
100
Riding on rainy days or waterlogged roads is not recommended.
The electric skateboard is not a toy, should be treated with appropriate caution. Ensure that you
use the board in a safe appropriate environment, and always wear appropriate safety gear.
Safety Gear: we recommend that you wear full safety gear while riding. Please wear a suitable
skateboard helmet, elbow pads, knee pads, and gloves.

RIDING OUTSIDE OF YOUR PRIVATE PROPERTY
Abide by the laws and regulations in your state or country.
Respect other drivers and pedestrians on the road.
Avoid riding in busy traffics and crowded areas.
Do not park your board in a way that blocks people or traffic,or may create a safety issue.
Cross road at designated crosswalks or signaled intersections.
When riding with other riders,keep a safe distance from each other and other transport devices.
ldentify and keep a safe distance from hazards and obstacles on the road.
Do not ride your board on private property unless you have obtained permission.
Do frequent maintenance checks,make sure all screws are tight before riding.
Clean the bearings regularly.
Turn off board and controller when not in use.
Recharge the battery in well ventilated area.
Do not charge the battery in area with might wet the board or charging units.
Do not leave the board charging unattended. Stop using the product or charging unit if any wire is damaged.
Only use charging units supplied by us.
Do not use the board battery to power any other equipments.
PRECAUTIONS FOR USE
STORAGE AND MAINTENANCE

BATTERY SAFETY
Lithium-ion battery can explode or cause a fire if they are used incorrectly.Therefore,it is recommended to read the
following instructions very carefully:
Each time before riding the board,carefully check the battery pack and especially the protective seal.Make it is
undamaged and intact.lf in doubt,take the battery to a chemical waste disposal facility.
Never drop the board.
Store the board with battery inside in a dry place.
Never expose the battery to tempreture above 100 celsius degrees.
Only use offical board charger for charging board battery.
Never leave the board unattended when charging.
Never make the board work when charging.
Charge fully the battery before first time use.This gives it better long-term performance.
●
●
●
●
●
●
●
●
lf you are not planning to use the board for about 2 months or longer, Charge it to
at least 50% - 60% and charge it once a month. A lithium-ion battery that has
been left empty for too long no longer be charged.

WARRANTY
LIMITED WARRANTY
FOR ALL RETURN AND WARRANTY SHIPPING
●
●
●
●
●
We offer 6 months (180 days) warranty on parts from the date when you receive the board.
If a defect arises during the Warranty Period, Company will , at is options :
1 ）Send the new parts to replace the defect parts.
2）Exchange the affected Products with functionally equivalent Products that are new or formed
from new and/or previously used parts that are equivalent to new in performance and reliability.
This warranty excludes damage resulting from abuse, accident, modifications, unauthorized repairs,
neglect, abuse, water damage, or other causes that are not defects in materials and workmanship.
This warranty excludes normal depletion of consumable parts (grip tape, wheels & bearings) unless
due to a defect in materials or workmanship.
This warranty excludes gifts.
Please keep your shipping box. The warranty does not include damage from shipping in insufficient
packaging.
The damage of skateboard caused by immersion of water will not be within the scope of warranty.

If the parameters are updated without notice, please refer to the official website.2022.03.31
www.possway.com After-sales service:
[e-mail]