Thank you for purchasing your PowaKaddy product.
Please follow all instructions for safe use and to get
the best out of your new PowaKaddy ThermaMitts™.
Important
USB-C Trolley Handle
ThermaMitts™
The ThermaMitts™ are only compatible with
PowaKaddy electric golf trolleys tted with USB-C
charging ports on the underside of the handle.
If your trolley does not have a USB-C port, you MUST
use the PowaKaddy PowaPack™.
DO NOT WASH - wipe clean only.
Material: 85% Polyester, 15% PU
For further information, please visit PowaKaddy.com
Product MUST be used with PowaKaddy PowaPack™
Do NOT Plug the PowaPack™ extension cable
directly into trolley.
The ThermaMitts™ have a large current draw not
suitable to PowaKaddy USB-A trolley models and will
cause damage to the trolley handle if this product is
not used as directed.
ThermaMitts™ MUST be used with the PowaKaddy
PowaPack™. Using an adaptor cable to connect the
ThermaMitts™ to the trolley handle directly will
invalidate your electric trolley warranty.
Using the PowaPack™:
1. With your PowaKaddy Electric trolley turned o:
2. Insert the trolley handle grips into the
ThermaMitts™, one side at a time.
3. Slide the grey bungee loops over the grips to
secure.
4. Use Extension cable (provided with the
PowaPack™) to connect the ThermaMitts™ to the
PowaPack™.
USB-A Trolley Range
5. When plugged into the PowaPack™, The
ThermaMitts™ LED button will cycle through the
heat setting colours. Once this has completed,
press, and hold the ThermaMitts™ power button
to power the ThermaMitts™ on.
6. Press the button to toggle through the High,
Medium, and Low heat settings.
7. Place the PowaPack™ in an empty pocket in your
golf bag where it will be secure and completely
dry.
8. Once you have completed your round, power o
the PowaPack™ by double pressing the on/o
button located on the right-hand side.
9. Once home, remember to charge the PowaPack™
and then store in a dry place out of direct
sunlight.
Product can be plugged directly into the trolley
handle.
1. Insert the handle grips into the ThermaMitts™,
one side at a time.
2. Slide the grey bungee loops over the grips to
secure.
3. Plug the ThermaMitts™ USB-C cable into the
trolley charging port.
4. Power on the trolley.
5. The ThermaMitts™ LED button will cycle
through the heat setting colours. Once this has
completed, press, and hold the ThermaMitts™
power button to power the ThermaMitts™ on.
6. Press the button to toggle through the High,
Medium, and Low heat settings.
7. Press and hold the LED button to power the
Mitts o.
Note:
• After 2 Hours, the ThermaMitts™ will
automatically turn o. Simply press and hold the
LED button to turn back on.
• If powering the ThermaMitts™ from the trolley
battery, the total range of the trolley will be
reduced.
Care
TYPE
USB-A
TYPE
USB-C
