Powerwow R1205C3 Series User manual

1
USER MAUNNAL
WIRELESS POWER RECEIVER
Model number: R1205C3DG, R1205C3ST, R1205C3I7, R1205C3S8, R1205C3CM
R1205C3XX (“XX” could be “CM”, “ST” or “DG”)
PHONE
Z-axisdistance
PHONECASE
PTU(Transmi er)
PRU(R1205-C3ST)

2
T1205C3XX User Manual / T1205C3XX 使用說明書
Key Feature
主要功能
Support mobile phones with Micro-B、Lightning
or Type-C connectors
When operating with AirFuel (A4WP) compatible
transmitter, it can Drop & go convenience, no
need to concern about alignment
可支援 Micro-B、Lightning 跟Type-C 手機
當接收來自 AirFuel (A4WP)傳送端的電力，放置
充電區域即可進行無線充電
Product Specification
產品規格
1. Model_: R1205C3XX
2. Output: 5W (5V/1A)
3. Over Voltage Protection to protect itself from
damage caused by unexpected induced rectifier
voltage
4. Over Temperature Protection to protect from
overheating
5. Current Limit to limit current at pre-configured
level
6. Dynamic current adjustment by referring to
temperature value
7. Dimension: 80 x 64 x 1.4mm
8. Weight: 15g
1. 型號: R1205C3XX
2. 輸出: 5W (5V/1A)
3. 過電壓保護，確保接收器不會因傳送端導致的高
感應電壓造成損壞
4. 過溫度保護，確保接收器不會因為溫度累積過
熱，造成損壞
5. 溫度限流設定，確保不會因被充電裝置不正常抓
取超高的電流
6. 隨著溫度高低，自動調整電流，避免過熱
7. 尺寸: 80 x 64 x 1.4 毫米
8. 重量: 15g
Before installation
安裝前注意事項
Make sure the connector of RECEIVER match the
connector of mobile phone you’d like to charge
確認接收器的 connector 與手機接孔相符
Installation Procedure
安裝步驟
Plug the male connector of RECEIVER into the mobile
phone connector and put them in the charging area
將接收器街頭插入於手機充電接孔並置於充電區域
Product Safety Reminder
產品安全提示
1. Slightly heat up during charging is normal
2. Please do not soaking in water, drop, bump, or
disassemble the product permission for
maintenance.
3. Please use PowerWoW PTU transmitter to ensure
1. 充電中本產品有輕微發熱為正常現象
2. 禁止浸水,摔落,撞擊或私自拆解本產品
3. 禁止使用其他非原廠電源線
4. 建議搭配使用 PowerWoW PTU 傳送器,以保證效
能

3
the performance.
Product Safety Information
產品安全訊息
FCC INFORMATION：
This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules and Canadian ICES-001-V4.
These limits are designed to provide reasonable
protection against harmful interference in a residential
installation.
This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there
is no guarantee that interference will not occur in a
particular installation. If this equipment does cause
harmful interference to radio or television reception,
which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the
interference by one of the following measures:
. Reorient or relocate the receiving antenna.
. Increase the separation between the equipment and
receiver.
. Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
. Consult the dealer or an experienced radio/TV
technician for help.
FCC Caution: (Notice)
To assure continued compliance, any changes or
modifications not expressly approved by the party
responsible for compliance could void the user's
authority to operate this equipment.
低功率電波輻射性電機管理辦法
第十二條
經型式認證合格之低功率射頻電機，非經許可，
公司、商號或使用者均不得擅自變更頻率、加大功率
或變更原設計之特性及功能。
第十四條
低功率射頻電機之使用不得影響飛航安全及干擾
合法通信；經發現有干擾現象時，應立即停用，並改
善至無干擾時方得繼續使用。
前項合法通信，指依電信法規定作業之無線電通
信。
低功率射頻電機須忍受合法通信或工業、科學及
醫療用電波輻射性電機設備之干擾。

4
IMPORTANT NOTE:
To comply with the FCC/IC RF exposure compliance
requirements, the antenna(s) used for this transmitter
must be installed to provide a separation
distance of at least 20 cm from all persons and must
not be co-located or operating in conjunction with any
other antenna or transmitter. No change to
the antenna or the device is permitted. Any change to
the antenna or the device could result in the device
exceeding the RF exposure requirements and
void user’s authority to operate the device.
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) this device may not cause harmful
interference, and (2) this device must accept any
interference received, including interference that may
cause undesired operation.