KoamTac KDC180 User manual

KDC180
Charging Cradle Mini Guide
Charging via DC Connector (10-Slot)
The 12V/10A DC power adaptor supports 5V normal
charging when KDC180 scanners are placed into the
charging cradle. (B)
Charging via USB Connector (2-Slot)
The 5V/2.4A USB adaptor supports 5V normal charging
when the KDC180 is placed into the charging cradle. (A)
1x KDC180 2-Slot Cradle with No-Boot Spacer
1x KDC180 2-Slot Cradle with UHF Spacer (Optional)
1x 5V/2.4A USB Adaptor
1x USB TYPE-C Cable
What’s in the Box? 2-Slot Cradle
1x KDC180 10-Slot Cradle with No-Boot Spacer
1x KDC180 10-Slot Cradle with UHF Spacer (Optional)
1x 12V/10A DC Power Adaptor
What’s in the Box? 10-Slot Cradle
12V/10A
ADAPTOR
With UHF Spacer
(Optional)
With No-Boot Spacer
With No Boot Spacer
With UHF Spacer (Optional)
* The shape of the adaptor may vary by country.

Cradle Power LED Status Battery LED Status
Main Power
Status LED
Green: Always on when the cradle is powered on
Orange: Charging
Green: Fully charged
Battery
Status LED
For all models other than the KDC180 with UHF, charge the
KDC180 by placing it into the cradle as shown below: (C)
Charging UHF Models (Optional)Charging with a Protective Boot
Make sure the UHF spacer is installed and then place the
KDC180 UHF model into the cradle as shown below: (F)
1. Remove the No-Boot spacer from the cradle by pulling
the tab on the back of the spacer up. (D)
2. KDC180 devices other than UHF models can now be
charged while wearing a protective boot. To charge, place
the KDC180 into the cradle as shown below: (E)
UHF Spacer
How to Charge Your KDC180
* KDC180W model with optional Inductive charging antenna
can be charged on both Qi compliant wireless charging pad
and charging cradle.