PRADO trim long User manual

cut a round hole (Ø 132 h 85)
1
Ø 132mm
light + ventilation | trim long
installation instruction

Use a step drill to cut a Ø20 hole into the Ø125 valve
adapter of your choice. A hole can be drilled in any
type or brand of Ø125 valve adapter.
2
Ø 20 mm

Connect the Ø16 preflex and the valve adapter with
the prado connector. Make sure to add minimal
300mm of wire into the valve adapter.
Driver must be placed remotely to remain accessible.
3
min. 300mm wire
POWER
OFF

Cut off the excess length of the valve adapter.
(between 0 and 25 mm above final ceiling level)
The remaining vertical part of the adapter (before the
start of the turn) must be at least 75 mm high for the
plaster ring (connector can’t be placed in this zone).
4
0-25mm
Ø125 Ø125
min 75mm

Insert the holder
5

if 50m /h is required
remove the 25m /h ring like shown above
if 25m /h is required
do not remove the 25m /h ring like shown above
push
6

gently pull the lock out before adjusting the air flow
pull
7
locked unlockedunlocked

connect the wires with waterproof connectors
for serial connection, respect polarity
combine with prado LED-driver
constant
current (mA)
typical forward
voltage (V)
typical
power (W)
16,9
17,4
18,2
18,5
5,9
8,7
12,7
15,7
350
500
700
850
driver
driver
10 mm
0.08 - 2.5mm
8
POWER
OFF

1. insert the wires into the connector
2. compress the middle part
3. seal with a heater
1
2
3
heat
9

gently insert the fixture into the kit until it “clicks”
10
“click”

twist the luminaire to adjust the ventilation flow level
1 8
11

insert the design ring to lock the ventilation valve
“click”
12

The light source in this luminaire shall only be replaced by the manufacturer
or a similar qualified person. Warranty will not apply in case of wrongful use
or if unskilled personnel attempts to repair the product.
prado.eu
IP 65
Replace glass lens when broken.
Luminaire shall only be used together with glass lens.
twist the luminaire as desired
thank you for choosing prado
30°
13
POWER
ON
360°