Premier Mounts iPad IPM-500 User manual

Installation Instructions Visit the Premier Mounts website at http://www.mounts.com
iPad™ IPM-500 Mounting Frame Installation Instructions
9531-056-041-00
Parts List
IPM-500
IPM-500
(Qty 1)
3130 East Miraloma Avenue
Anaheim, CA 92806 USA
USA and Canada
Phone: [phone]
Fax: [phone]
Other Locations – Phone: [phone]; Fax: [phone] ©Premier Mounts 2011
The IPM-500 open mounting frame securely holds the Apple iPad™ or
iPad2™ (not included) in place and gives access to all iPad™ controls
and connections. Its removeable wall mount plate may be installed on
any single stud surface, and provides 360° rotation for landscape or
portrait placement.
• All trademarks are the property of the respective trademark owners.
Step 3
Are you installing an original
iPad™ or iPad2™ to the
IPM-500?
If an original iPad™, remove
the corner felt pads on the
IPM-500. Then continue to
step 4 below.
If an iPad2™, continue to
step 4 below.
Step 4
➊Extend the arms of the IPM-500.
➋Insert the iPad™ in the IPM-500.
Each arm of the IPM-500 should
t over a corner of the iPad™.
Remove if using original iPad™
Remove if using original iPad™
#8 x 1¼” Wood Screw
(Qty 2)
Step 1
Remove the wall plate from the
IPM-500.
Step 2
Use two (2) #8 x 1¼” wood screws
to attach the wall plate to a single
wood stud.
#8 x 1¼” Wood Screw

Page 2 Visit the Premier Mounts website at http://www.mounts.com Installation Instructions
IPM-500
Step 5
➊Adjust the arms on the IPM-500
so that the iPad™ ts snuggly
inside the mount (Figure 1).
➋Tighten the two (2) pre-installed
Phillips screws on the back of
the IPM-500 to secure the arms
(Figure 2).
Step 6
➊Insert the IPM-500 into the wall
plate.
➋Rotate the mount to the desired
landscape or portrait position.
➌Tighten the two (2) pre-installed
M4 x 16mm pan combo screws
on the sides of the wall plate.
Mounting tab on IPM-500
Figure 1
Figure 2
Phillips screws
IPM-500 Installation Instructions (cont’d)