Premier Mounts RTM Series User manual

Installation InstructionsInstallation InstructionsInstallation InstructionsInstallation Instructions
RTM Series Ceiling Adapter
Model: RTM-C
NORTH AMERICA
3130 East Miraloma Avenue
Anaheim, CA 92806 USA
USA and Canada -
Phone: [phone]
Fax: [phone]
EUROPE
Swallow House,
Shilton Industrial Estate,
Shilton, Coventry, England CV79JY
Phone: [phone]
Fax: [phone]
Other Locations - Phone: [phone]; Fax: [phone]
©Premier Mounts 2007
9531-009-031-01
AUSTRALIA, NEW ZEALAND,
OCEANIA (Distributor)
P.O. Box 295
Mordialloc Victoria 3195
Australia
Phone: [phone]
www.premiermounts.com.au

RTM-C
Page 2 Installation Instructions
Warning Statements 2
Parts List 3
Installation Tools 3
Attaching the RTM-C to the RTM 4
Attaching the RTM-C to the Suspension Pole 5
Optional Configurations 6
Technical Specifications 6
Warranty 7
Contact Premier Mounts 7
Warning Statements
WARNING: PREMIER MOUNTS DOES NOT WARRANT AGAINST DAMAGE CAUSED BY THE USE OF ANY PREMIER
MOUNTS PRODUCT FOR PURPOSES OTHER THAN THOSE FOR WHICH IT WAS DESIGNED OR DAMAGE
CAUSED BY UNAUTHORIZED ATTACHMENTS OR MODIFICATIONS, AND IS NOT RESPONSIBLE FOR ANY
DAMAGES, CLAIMS, DEMANDS, SUITS, ACTIONS OR CAUSES OF ACTION OF WHATEVER KIND RESULTING
FROM, ARISING OUT OF OR IN ANY MANNER RELATING TO ANY SUCH USE, ATTACHMENTS OR
MODIFICATIONS.
WARNING: THE CEILING MUST BE CAPABLE OF SUPPORTING 320 LBS. IF NOT, THE MOUNTING SURFACE MUST BE
REINFORCED. PROPER INSTALLATION PROCEDURES BY A QUALIFIED SERVICE TECHNICIAN, AS OUTLINED
IN THE INSTALLATION INSTRUCTIONS, MUST BE ADHERED TO. FAILURE TO DO SO COULD RESULT IN
SERIOUS PERSONAL INJURY, OR EVEN DEATH.
WARNING: SAFETY MEASURES MUST BE PRACTICED AT ALL TIMES DURING THE INSTALLATION OF THIS PRODUCT.
USE PROPER SAFETY GEAR AND TOOLS FOR THE INSTALLATION PROCEDURE TO PREVENT PERSONAL
INJURY.
WARNING: PRIOR TO THE INSTALLATION OF THIS PRODUCT, THE INSTALLATION INSTRUCTIONS SHOULD BE READ
AND COMPLETELY UNDERSTOOD. THE INSTALLATION INSTRUCTIONS MUST BE READ TO PREVENT
PERSONAL INJURY AND PROPERTY DAMAGE. KEEP THESE INSTALLATION INSTRUCTIONS IN AN EASILY
ACCESSIBLE LOCATION FOR FUTURE REFERENCE.
Indicates that the power plug is to be disconnected from the power outlet.
Safety precautions must be taken at all times.
Warning and Caution statements.
A secure structure must support the weight, or load, of the display.
Do not install on a structure that is prone to vibration, movement or chance of impact. Failure to do so could result in damage to
the display and/or damage to the mounting surface.
Do not install near heater, fireplace, direct sunlight, air conditioning or any other source of direct heat energy. Failure to do so
may result in damage to the display and could increase the risk of fire.
At least two qualified people should perform the installation procedure. Injury and/or damage can result from dropping or
mishandling the display.
Contact Premier Mounts with any technical/installation questions.

RTM-C
Installation Instructions Page 3
Parts List
NOTE: The RTM-C may be used with the RTM-L or the RTM-S Series Display Mounts. It is
imperative that the installation instructions be read for these mounts prior to installation.
The installation instructions that are contained herein are exclusively for the RTM-C.
NOTE: This adapter is shipped with all installation hardware and components. Make sure that none of
these parts are missing and/or damaged before beginning installation. If there are parts missing
and/or damaged, please stop and contact Premier Mounts [phone].
Cable Ties
(Qty 2)
RTM-C (Qty 1)
M5 Allen Wrench
(Qty 1)
M6 x 10mm Phillips
Head Screw (Qty 1)
M8 x 20mm Button Hex
Head (Qty 4)
M3 Allen Wrench
(Qty 1)
Installation Tools
Phillips Head Screw Driver Soft Material/Blanket Pencil
Tape Measure M5 Allen Wrench (Supplied)
M3 Allen Wrench (Supplied)

RTM-C
Page 4 Installation Instructions
NOTE: The installation instructions that are contained in this manual refer only to the RTM-C. The
installation instructions for optional configurations (page 7) that are used with the RTM-C will be
included with those products.
NOTE: Prior to installing the RTM-C, the RTM-C must be attached to the RTM-L or the RTM-S.
Attaching the RTM-C to the RTM
1. Remove the set screws from the mounting
block on your Rotary Series Mount (two are
located on each side of the mounting block)
using the 5/32” Allen wrench (supplied with
the RTM-S and the RTM-L).
Mounting
Block
Set Screw
5/32” Allen
Wrench
M8 x 20mm
Button Hex
Head Screws
RTM-C
M5 Allen Wrench
2. Place the RTM-C (flat edge facing the rear)
onto the RTM and line up the mounting holes.
3. Insert four (4) M8 x 20mm button hex head
screws into the mounting and tighten
using the M5 Allen wrench (supplied).
4. After tightening the M8 x 20mm button hex
head screws, place the RTM-C to the side and
determine where the suspension pole will be
installed.
NOTE: Please refer to the installation
instructions that are included in the
packaging of the mount that will be
used for the next steps.
Flat Edge

RTM-C
Installation Instructions Page 5
Attaching the RTM-C to the Suspension Pole
Once the mounting configuration has been determined and installed, the RTM-C may be attached.
NOTE: Depending on the installation configuration, a 1-1/2” NPT must be installed prior to installing
the RTM-C.
NOTE: It is recommended that two people install the RTM-C. While one person attaches the RTM-C onto
the suspension pipe, the other person must hold the ladder.
1. Place the RTM-C coupler onto the threaded end
of the suspension pole. Thread the coupler onto
the threaded pipe tighten at least seven (7)
complete turns.
2. After the RTM-C has been threaded onto the
1-1/2” NPT, tighten the M6 x 10mm
set screw using a M3 Allen wrench (supplied).
3. Use the cable management holes, along with
the cable ties, to secure and hide any loose
cables and wires.
Threaded Pipe
RTM-C
M3 Allen
Wrench
Cable
Management
Holes
M6 x 10mm Set
Screw
Cable Management
Holes

RTM-C
Page 6 Installation Instructions
Optional Configurations
You may use the RTM-C with the following optional accessories. Please refer to the Installation Instructions
that come packaged with the following products.
Technical Specifications
All measurements are in inches (mm).
AST-2446 APP-2446 AST-1321

RTM-C
Installation Instructions Page 7
PREMIER MOUNTS
LIMITED LIFETIME WARRANTY
What and Who is Covered by this Limited Warranty and for How Long
Premier Mounts warrants this product to be free from defects in material and workmanship for the lifetime of the original owner of this
product. The limited warranty is valid only for the original purchaser of the product.
What Premier Mounts Will Do
At the sole option of Premier Mounts, Premier Mounts will repair or replace any product or product part that is defective. If Premier
Mounts chooses to replace a defective product or part, a replacement product or part will be shipped to you at no charge, but you must
pay any labor costs.
What is Not Covered; Limitations
PREMIER MOUNTS DISCLAIMS ANY LIABILITY FOR DAMAGE TO MOUNTS, ADAPTERS, DISPLAYS, PROJECTORS,
OTHER PROPERTY, OR PERSONAL INJURY RESULTING, IN WHOLE OR IN PART, FROM IMPROPER INSTALLATION,
MODIFICATION, USE OR MISUSE OF ITS PRODUCTS.
PREMIER MOUNTS DISCLAIMS ALL OTHER WARRANTIES, EXPRESS OR IMPLIED, INCLUDING WARRANTIES OF
MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. PREMIER MOUNTS IS NOT RESPONSIBLE FOR
INCIDENTAL OR CONSEQUENTIAL DAMAGES, INCLUDING BUT NOT LIMITED TO, INABILITY TO USE ITS PRODUCTS
OR LABOR COSTS FOR REMOVING AND REPLACING DEFECTIVE PRODUCTS OR PARTS. SOME STATES DO NOT ALLOW
THE EXCLUSION OR LIMITATION OF INCIDENTAL OR CONSEQUENTIAL DAMAGES, SO THE ABOVE LIMITATION OR
EXCLUSION MAY NOT APPLY TO YOU.
What Customers Must Do for Limited Warranty Service
If you discover a problem that you think may be covered by the warranty you MUST REPORT it in writing to the address below within
thirty (30) days. Proof of purchase (an original sales receipt) from the original consumer purchaser must accompany all warranty claims.
Warranty claims must also include a description of the problem, the purchaser’s name, address, and telephone number. General inquiries
can be addressed to Premier Mounts Customer Service at 1-800-368-9700. Warranty claims will not be accepted over the phone or by
fax.
Premier Mounts
Attn: Warranty Claim
3130 E. Miraloma Avenue
Anaheim, CA 92806
How State Law Applies
THIS WARRANTY GIVES YOU SPECIFIC LEGAL RIGHTS, AND YOU MAY ALSO HAVE OTHER RIGHTS WHICH VARY
FROM STATE TO STATE.