Before Start
Use one of the following methods to get Killer B™to regain his shape:
• Place Killer B™under HOT water.
• Use a hair dryer to warm Killer B™.
• Place Killer B™outside on a warm sunny day.
These methods will pop him back into his original shape.
Assembly of Killer B™
Step 1 - INSTALL STAKE INTO DECOY - (See Diagram 1)
-Make sure that the stake gets installed through the stabilizer bracket during installation.
NOTE: Bottom section of stake easily installs and removes for compact carry.
Step 2 - ATTACH SILK FAN TO FAN BRACKET - (See Diagram 2)
NOTE: For added realism add real feathers to the Mobile™Series Real Fan Holder. (See Next Page)
TIP: You may trim Killer B’s™beard to the length you desire.
Top Section
of Stake
Bottom Section
of Stake with
welded side piece
Diagram 1
Front of
Decoy
Washer
Twist
Foot Peg
Stabilizer
Bracket
Wing Nut
Diagram 2
Wing Nut
Plastic Rods
Fan Bracket
Fan Screw
Diagram 3
Setting Up Killer B™For Use
Step 1 - **IMPORTANT** Install stake into ground with foot peg facing towards the front of the decoy,
toward direction of pulling line (See Diagram 3). This will keep the decoy from tipping over when pulling the
line towards you (See Diagram 4).
Step 2 - Attach 90’ Pull Line to O-Ring on front of decoy above beard (See Diagram 5).
Diagram 4 Diagram 5
O-Ring
90’ Pull
String
Correct Set-Up
Foot Peg facing toward front of decoy
Incorrect Set-Up
Foot Peg facing toward back of decoy
2 Washers
