Pro Breeze PB-AC05 User manual

Instruction manual
Model PB-AC05
12000 BTU Portable Air Conditioner

Portable Air Conditioner
Safety Warning
Contents Pg

Specific Information
Regarding R290
Refrigerant Gas

Caution
Specifications

Parts
Front View
Rear View
Accessories

Control Panel
1. Buttons moving from left to right
•
•
•
•
•
•
2. Indicator light symbols moving from
top to bottom and left to right
•
•
•
•
•
•
•
•
•
3. Digital display panel moving from top
to bottom
•
•
Remote Control
Note:

Installation
Prior to and after installation adhere to
the below:
•
•
•
Leave the appliance in an upright
position for at least two hours prior
to first use.
Heat Exhaust Hose Installation
Sliding Window Sealing Board Assembly
Installation
Notes:
•
•

Hinged Window Sealing Fabric
Assembly Installation
1. Open window and clean frame and
casement surfaces of dust and
particles.
2. Stick the velcro tape around the
entire window frame. Never stick
to the window seal as doing so will
prohibit the window from closing fully.
3. Stick the velcro tape around the
entire window casement (inside or
outside). Check to ensure the window
can close fully.
4. Attach side A of the sealing fabric
assembly to the velcro on the window
frame working from the centre
outwards.
5. Close and open window to ensure no
fabric gets trapped.
6. Attach side B of the sealing fabric
assembly to the velcro on the window
casement working from the centre
outwards.
7. Open the window slightly and
insert the heat exhaust hose short
connector into the sealing fabric
assembly securing with the zippers
around its lip.
8. The sealing fabric assembly is now
ready for use.
Notes:
• Do not bend the heat exhaust hose in
excess of 45 degrees. It should be as
short and as straight as possible to
• Do not overstretch the heat
exhaust hose as this may affect the
Frame
Side A
Side B
Casement
7
4 & 6
2 &3
Hinged window sealing fabric zip

Controls
Control Panel
Power Button
Mode Button
• Cooling Mode
• Fan-Only Mode
• Dehumidifying Mode
• Heating Mode
Note:
Fan Speed Button
Note:

Timer Button
Note:
Up And Down Buttons
•
•
•
Swing Button (Remote Control Only)
Temperature Unit Change Button
(Remote Control Only)

WiFi And Smart Life App
Set-Up
Note:
Amazon Echo Set-Up
Notes:
•
•
•
1. Link the Amazon Alexa app to the
Smart Life app:
2. Pair the Amazon Alexa app to the
appliance:

Google Home Set-Up
Notes:
•
•
•

Emptying The Water Tank
3
4
2

Connecting The Water
Hose for Continuous
Drainage
1
2

Cleaning
General Cleaning
Heat Exhaust Pipe Cleaning
Filter Cleaning

Storage Safety Features
Anti-Frost Protection
Anti-Overheat Protection
Automatic Defrosting

Compressor Delay Protection
Disposal

Helpful Information
Issue Cause Resolution
The appliance is not operating.
No power. Connect the unit to a live power
socket and turn it on.
Water tank full. Drain the water stored in the
unit.
It is recommended that this unit
be operated at 5-32°C.
the set temperature in cooling
mode.
Increase the set temperature
above the room temperature.
Poor cooling.
Doors and windows are open or
there are other heat sources.
Close doors and windows and
remove other heat sources.
Air inlet or air outlet clogged.
There is direct sunlight. Draw curtains.
Noisy. surface.
The compressor does not work. Initiation of overheat protection.
Wait three minutes until the
temperature decreases and
then turn on the unit.
The remote control does not
work.
Too far from appliance. Bring the remote control closer
to the appliance and ensure
that the remote control is
pointing toward the receiving
head of the remote control.
The remote control is not
pointing towards the receiving
head of the remote control.
The batteries are dead.
Display showing E1. Pipe temperature sensor failure.
Arrange for a professional to
check the pipe temperature
sensor and related circuits.
Display showing E2. failure.
Arrange for a professional to
check the room temperature
sensor and related circuits.
Display showing E4. Anti-frost protection.
Appliance returns to operating
at chosen settings once the
internal pipe temperature
exceeds 8°C.

One Retail Group, Ryland House
24a Ryland Road, London, NW5 3EH, United Kingdom
EU Authorised Representative: Brandrep Limited
The Black Church, St Mary's Pl N, Dublin, D07 P4AX, Ireland
© Copyright 2021