3
A) Switch On
To start the device, please press the On/Off button for 4-5 seconds till the green
and blue LED lights on, device is then started. When the blue LED goes off in
second, it gets ready for recording now.
B) Switch Off
Press the On/off button for about 4-5 seconds will switch off the device manually,
or leave the device without operation for 20 seconds, it will shut off automatically.
C) Recording
1. Start to record
In power on mode, one short press of recording button, it will start recording.
Blue LED lights will blink to show that device is working properly. This lights
can also be noticed by your peripheralvision when glasses worn on nose.
2. Stop and Save
One short press of the recording button, device will stop recording and you
will see the blue LED lights on and remain illuminated for a few seconds, now
the devices are saving data to its in-built memory. When blue lights goes off,
data saving finished and device is ready for next recording.
3. Auto shut-off
If you leave the device without operation for 20 seconds, it will automatically
shut off for power saving. You need to restart it again if you want to do new
recording.
A) The device has a standard in-built 2GB memory.
B) Device also offers micro SD card slot for extended memory.
C) Under default saving mode, if micro SD card inserted, data will be saved into
micro SD card first, when it’s full, data will be saved into the in-built flash
memory.
D) When space is full, LED light will stop blinking and start data saving; If in-built
memory is full, device will shut off after data saving.