Professional Pool Products 100 Series User manual

INSTALLATION
MANUAL
10 0 xx
Plastic
LED Underwater Light

INSTALLATION
ADDITIONAL DATA
1. All lamps should be placed on the wall of
the pool at approximately 500mm below
the water surface, in areas that are easily
accessible from the upper edge of the pool.
2. It is highly recommended to use the
underwater cable gland (provided).
3. All lamps should be installed on the same
transformer and switch.
4. The lamp is supplied with 4m of cable, making
it possible to install multiple lamps connected
to a single junction box.
Prior to concreting, place a ¾” threaded female
adaptor 500-700mm below water surface level,
making sure the face of the adaptor is xed
ush against the future nished wall level of your
pool interior. This socket will be used for xing the
underwater gland (provided) for a watertight
installation.
Pass the electrical cable through the gland
assembly, into the adaptor/conduit, up until it
reaches the junction box located on the deck.
Now you may fully tighten the seal nut into the
gland while keeping approx 45cm of cable free,
which can easily be wound behind the lamp
during installation.
Place the lamp over the desired location, mark
the holes, drill with a 6mm Ø bit, insert the two
anchor plugs, wind the cable behind the lamp,
fasten using the two stainless steel screws provided
and plug these holes using the rubber inserts.