
Pedal Plate
Pedal Pad
Page 2 of 4
730182 - FUSION 8x8 STARTING BLOCK
INST730182
8/1/2015
800-637-3090
www.gillathletics.com
All rights reserved.
Copyright 2015 by Gill Athletics.
INSTRUCTIONS
- Allen Key (provided)
bottom of each pedal.
4. Handle
Gently wiggle the tab to help it through the hole. Be careful not
2. False start bracket
- Spike Wrench
Fasten the handle to the front of the rail with the flat head
towards the open end of the rail.
screw provided.
Slide each pedal onto the rail so that the pedal pad is facing
3. Pedals
1. Pedal pads
to pull the tab off of the pedal pad.
The FUSION starting block is shipped unassembled.
The following tools are needed:
- Needle Nose Pliers
Use one hand to press on the pedal pad. Use the other hand to
the false start bracket.
gently pull the tabs through the holes with needle nose pliers.
Make sure that the "teeth" of the rail are pointing away from
Set the angle of the pedal to the 60 position.
Insert the tabs on the pedal pad into the holes in the pedal plate.
Fasten the false start bracket to the back of the rail with the
flat head screw provided.
Flip the starting block over and install the spikes into the
5. Spikes
Rail
False Start Bracket
M8 x 16mm Flat Head Cap Screw
(M2829)
(M2829)
Rail
M8 x 16mm Flat Head Cap Screw
Handle