STEP BY STEP USE GUIDE:
1. Install your slot style receivers into the openings on the front of the PSC RF SR 4 Slot
Rack noting the correct direction of the DB-25 connectors. Gently slide the receivers
into the slots until you feel the DB-25 connectors line up. Once you feel the connectors
line up, firmly press the slot receiver fully into place. Lock your receivers into place
using the M3 Metric thread screws on the receivers.
2. Connect your audio output cables from the eight TA3M audio outputs or from the DB-
25 connector to your mixer or recorder’s inputs. Either connector type can be used with
either analog or AES digital signals. Please note that the DB25 multi-channel audio
snake connection is wired using the industry standard “Tacam” wiring for ease of use.
3. Connect either a 12 VDC power source to the 4 pin XLR external power connector or
connect the unit to AC power using the AC power receptacle.
4. Connect your two receiver antennas to the RF input BNC connectors on the rear panel
of the unit. When using powered antennas or remote line amplifiers, turn on the
“Antenna” power switch. For all other uses, leave this switch turned off.
5. Power up the unit by turning on the main power switch located on the left hand end of
the front panel. Note that the BLUE LED located adjacent to the powers switch will light
up power when the unit is turned on.
*NOTES*
1. Different brands of wireless receivers require their own specific brand made
adapters to work with our Four Pack. These are the same adapters required to install
the slot receivers in an Ikigami or Panasonic camera. For example:
Lectrosonics SRB requires their “SRUNI” kit.
Wisycom MCR42 requires their “SCK42-IK-PSC”kit.
Audio Limited A10-RX no adapter needed.
