PTAC LL2B User manual

Description
Leveling legs are designed to provide extra front support
and leveling of the wall sleeve. Two leg assemblies are
required per unit and are provided in each kit. Four
screws are also provided with each kit for attachment to
the wall sleeve. See Figure 1.
The leveling legs must be installed before the chassis is
installed, but after the wall sleeve is in place. Holes must
be drilled in each side of the wall sleeve, below the duct
package holes, for attachment to the wall sleeve.
The installation and servicing of the equipment referred to
in this booklet should be done by qualified, experienced
technicians.
The installation and servicing of the equipment should be
done by qualified, experienced technicians.
PTAC
LEVELING LEGS KIT (LL2B)
INSTALLATION INSTRUCTIONS
Part No. A3495502
Printed in USA
April 2005
ADJUSTER SCREW
SPEED GRIP NUT
LEVELER BRACKET
1/2"
1/4"
1"
NOTES:
1. Two leveling legs are supplied in each kit.
2. One kit is required per unit.
3. Four mounting screws are provided in each kit.
PTAC DIRECT SALES, INC.
185 S. Kimball Ave., Suite 130
Southlake, TX 76092
877.454.7822 (T)

2
To install the leveling leg assembly, complete the follow-
ing:
1. Drill two 1/8-inch holes in each side of the wall sleeve,
as shown in Figure 2, using the leveling leg assembly
as a template. Locations near the front of the sleeve
provide more support.
2. Adjust the leveling legs to the approximate height
needed (minimum 3 inches) and install them on either
side of the wall sleeve, using the screws provided.
Bottom of wall sleeve can be anywhere from three (3)
to five (5) inches above the screw base. Caulk around
screws to prevent water leaks.
3. Level the sleeve horizontally from side-to-side. Provide
a slight slope (one-quarter bubble in the sight glass)
toward the outside. Check the level again after the unit
has been installed. Adjust the legs as needed.
INSTALLATION
CHECKLIST
The following is an abbreviated guide to leveling leg
installation. Refer to the appropriate sections for more
detailed information.
RECEIVING
• Compare kit identification number with sales order to
ensure that the correct has been received.
• Inspect the leveling legs for shipping damage. File
damage claims with the delivering carrier immediately.
INSTALLATION
• Drill four 1/8-inch diameter holes in the wall sleeve, two
on each side, using the leveling legs as a template.
Caulk around the screws to prevent water leakage.
• Attach the legs to the wall sleeve, using the screws
provided.
• Adjust the leveling legs to level the wall sleeve from
side to side and provide a slight pitch to the outside
(one-quarter bubble in the sight glass).
Due to a policy of continual product improvement the right is
reserved to change specifications and design without notice.
INSTALLATION
The installation and servicing of the equipment referred to in this booklet should be done by qualified, experienced
technicians.
1/8" DIAMETER HOLES
(FOUR REQUIRED PER UNIT)
FIELD-DRILLED
3" Minimum
5" Maximum
2" Max. Adjustment
PTAC DIRECT SALES, INC.
185 S. Kimball Ave., Suite 130
Southlake, TX 76092
877.454.7822 (T)