Puls ZM1.WALL User manual

Headquarters: PULS GmbH, Elektrastr. 6, 81925 Munich, Germany, www.pulspower.com
Germany [phone]
China [phone] France [phone] North America [phone] Austria [phone] Singapore [phone] Switzerland [phone] United Kingdom [phone]
The information in this document is believed to be accurate and reliable and may change without notice.
EN ZM1.WALL Installation Manual Wall/Panel Mount Bracket
DE ZM1.WALL Installationsanleitung Wandmontageadapter
FR ZM1.WALL Manuel d'installation Kit de montage mural
ES ZM1.WALL Manual de instalación Soporte de montaje en pared/panel
Doc. ID: PU-200.100.75-xxZ (2019-01-10-MR1)
Product Description
The ZM1.WALL is a mechanical accessory to mount a device on a flat surface or
panel without utilizing a DIN-rail.
The order number ZM1.WALL contains two brackets needed for one device.
Intended Use
This mechanical accessory is designed for DIN-rail devices. Check the product
datasheet of the DIN-rail device to confirm that it is suitable for the desired device.
Technical Data
Size (width x height x depth) 143x8x7mm
Weight 50g / 0.11lb
Mechanical Dimensions
All dimension in mm
Mounting Example

ZM1.WALL Installation Manual
Installation Instructions
1) Detach the two aluminium brackets by removing the four screws with a Torx 10 screwdriver.
2) Remove the plastic lock mechanism by using a flat-blade screwdriver to move the lock downwards while at the same time push the plastic slider
upwards. Detach the plastic slider.
3) Mount the steel brackets with the same screws from the DIN-Rail brackets. Be careful not to over- tighten the screws! Recommended tightening
torque is 0.6Nm/ 5.3lb.in.
WARNING - Risk of electrical shock, fire, personal injury or death.
Do not use other screws than the one from the DIN-Rail bracket. The unit might become unsafe when using longer screws as contact with live
electrical circuits may occur.
Installation Instructions