PULSE+ LTS User manual

Multi-Purpose Laptop Stand
Model: LTS
www.pulse-audio.co.uk
CongratulationsonyourpurchaseofthePULSELTS,Multi‐PurposeLaptopstand.
Pleasereadthefollowingassemblyinstructionscarefully.Wehopeyouenjoyyour
newpurchase!

Parts:Removeallpartsfromtheboxandidentifythem.


RequiredTools:Philipsheadscrewdriver.

SupportAssembly:

1.TakeoneoftheUpperSupportsandplaceitoverthe
outsideofoneoftheLowerSupports(SeeFigureA).Align
theUpperSupportholeswiththeLowerSupportmounting
holestoobtainthedesiredheight.

2.Oneatatime,placeoneknobthroughthemounting
holes(mustbespacedatleast2holesapart).


3.TakeaStabilizerBarandscrewthetopknobintotheend
oftheStabilizerBar.Repeatwithbottomknob.

4.Install1inchspacersoneachStabilizerbartoincrease
standwidth.RepeatStep3withtheotherUpperSupport
andLowerSupportfortheoppositesideofthestand(see
FigureB).Tightenallknobstominimizewobble.

5.Dependingonuseofstand,pleaserefertooneofthe
followingmountoptionsbelow.

TableTopStand:

1.Usingfour(4)A‐screwsandwashers,attachtheflatfootbarto
thelowersupport.(SeeFigureC)

2.Repeatstep1ontheoppositesideofthestand.

C‐ClampTableMount:

1.Turntheclampsothattheknobfacesdown.Usingtwo(2)
B‐screwsandwashers,attachtheclamptothelowersupport.
(SeeFigureD)

2.Repeatstep1ontheoppositesideofthestand.

C‐ClampDJCoffinMount:

1.Turntheclampsothattheknobfacesout.Usingtwo(2)
B‐screwsandwashers,attachtheclamptothelowersupport.
(SeeFigureE)

2.Repeatstep1ontheoppositesideofthestand.