Pure Acoustics XTI100 User manual

XTI100
THE PURE SOUND OF LIFE
PURE ACOUSTICS
XTI100
SERIES
Owner’s Manual
®
www.pure-acoustics.com
Pure Acoustics, Inc. 18 Fuller Place, Brooklyn,
NY 11215, USA, Tel [phone]

Thank you for purcha ing Pure Acou tic ’ product , and welcome to the Pure Acou tic family of
ati fied cu tomer !
Pure Acou tic wa e tabli hed to fulfill the need for high quality peaker of exceptional de ign at
an affordable price. After year of re earch and development, and by manufacturing all part our elve
- from the voice-coil to the uniquely-de igned cro over - Pure Acou tic i able to offer you peaker
of uperior value.
Each peaker component ha been de igned and engineered with fir t-rate material to produce
exceptional ound. Our peaker offer the be t of it all – high-quality ound, hand-made olid
con truction, and a remarkably tyli h appearance.
We welcome you to witne the re ult . Our team’ dedication to quality, reliability and attractive
de ign ha created ome of the be t-value peaker you can find today.
Reading thi manual fully will help you to et up your peaker properly and reward you with a fine
li tening experience. Pure Acou tic di tribution center in Europe, A ia, Au tralia and the America
will be happy to a i t you with any que tion you may have. Plea e look for the di tributor neare t
you on our web ite, www.pure-acou tic .com.
Make ure all equipment i turned off. When connecting the peaker , be ure to retain the correct
polarity. Mo t peaker cable will have (+) red ign for po itive and (-) black ign for negative.
Connect the peaker cable to the po itive (+) front-left peaker terminal on the amplifier and to the
po itive (+) terminal on the front-left peaker. Connect the peaker cable to the negative (-) front-left
peaker terminal on the amplifier and to the negative (-) terminal on the front left peaker. Repeat
the ame tep for the right- ide front peaker. Thi method can be applied to bi-wire terminal a
long a the horting trap are in place. If your amplifier i equipped with bi-wire output connection,
remove the horting trap and connect each terminal to the a ociated terminal in your amplifier.
Connect the peaker cable to the po itive (+) center peaker terminal on the amplifier and to the
po itive (+) terminal on the center peaker. Connect the peaker cable to the negative (-) center
peaker terminal on the amp and to the negative (-) terminal on the center peaker.
Connect the peaker cable to the po itive (+) rear left peaker terminal on the amplifier and to the
po itive (+) terminal on the rear-left peaker. Connect the peaker cable to the negative (-) rear-left
peaker terminal on the amplifier and to the negative (-) terminal on the rear-left peaker. Repeat
the ame tep for the right- ide rear peaker.
Introduction
Connections

THE FRONT SPEAKERS hould be placed on each ide of your TV or in front of your favorite li tening
po ition. A a general guideline the pace from the peaker to the li tening po ition hould be 1.5
time the di tance between the peaker . For example if your li tening po ition i 9ft (2.7m) away from
the peaker , the di tance between the peaker hould be 6ft (1.8m)
THE CENTER CHANNEL SPEAKER hould be on top of or ju t above your TV.
THE REAR (SURROUND) SPEAKERS hould be po itioned either to the ide of, or behind, your li tening
po ition. Typical placement i on the ide wall , lightly above ear level, about two-third of the way
back from the front of the room. Thi allow the urround peaker to aim directly at the li tener, placing
you in the middle of a five- peaker ound field.
The performance of the peaker may change during the initial u e due to torage and mechanical
limitation . Plea e allow 15 hour of u e for the temperature effect and mechanical part to attain their
intended de ign characteri tic .
Make ure to turn all equipment off before cleaning. The cabinet only require occa ional du ting.
Plea e avoid touching the drive unit .
Position
Running time and cleaning
Set-Up Diagram
Left
Front
Speaker
Left
Surround
Speaker
Center Speaker
Receiver
Right
Front
Speaker
Surround Speaker
REARCENTER LR
CLR
FRONT Right
Surround
Speaker
Dolby

Limited one-year warranty
Technical Specifications
De ign and pecification are ubject to change without notice.
www.pure-acoustics.com
XTI-F XTI-C XTI-S
250 atts
38Hz - 22Khz
92db
4 - 8 Ohm
3 way Drav Fig.
Two 6.5” (165-mm) woofer FPC
CON for low frequencies
One 6.5” (165-mm) Mid-Driver
FPC CON for mid frequencies
1” (25-mm) silk SCOS dome
2500 / 3500 Hz
106x20x31 Cm.
16 Kg (each)
Black, Silver, Cherry, Beech,
Mahogany, Maple
Black cloth
No
150 atts
60Hz - 150Khz
91db
4 - 8 Ohm
2 way DRAV FIG. magnetic
shielding bass reflex
Two 5.25” (133-mm)
midwoofer- driver FPC CON
1” (25-mm) silk SCOS dome
2700 Hz
17x54x19 Cm
6 Kg (each)
Black, Silver, Cherry, Beech,
Mahogany, Maple
Black cloth
Yes
150 atts
65Hz-150Khz
90db
4 - 8 Ohm
2 way DRAV FIG.
One 5.25” (133-mm)
midwoofer- driver FPC CON
1” (25-mm) silk SCOS dome
3500 Hz
32x17x19 Cm
9 Kg (pair)
Black, Silver, Cherry, Beech,
Mahogany, Maple
Black cloth
No
POWER HANDLING
FREQUENC RESPONSE (+/-3dB)
SENSITIVIT (+/-3dB)
IMPEDANCE
DRIVER COMPLEMENT
WOOFER
MIDRANGE
TWEETER
CROSSOVER FREQUENC
DIMENSIONS (HXWXD)
WEIGHT
FINISH
GRILLE
VIDEO SHIELDING
Pure Acou tic product have been de igned and manufactured to the highe t quality tandard . However,
in the event that omething malfunction , Pure Acou tic and your local authorized di tributor warrant
free of charge part and labor ( ome exclu ion may apply) for a period of one year. Thi warranty i
only valid for the original owner. Thi warranty i limited to the repair of the product. Thi warranty will
not apply to unit that were ubject to mi u e, neglect, abu e, alteration or improper in tallation. Thi
warranty will not cover damage due to fire, water, heat, lightning or any other cau e beyond the control
of Pure Acou tic . Retention of your original dated recipe i required in order to obtain warranty ervice
from your local authorized Pure Acou tic Dealer.