Pure Resonance Audio PRIVACYCARD PRA-PRIVACY-WHT User manual

PRIVACYCARD™QUICK START GUIDE
Caution: Please read this manual carefully before operating.
Damage caused by misuse is not covered by the warranty.
PRIVACYCARD™ USB SOUND MASKING GENERATOR

INSTALLATION & OPERATION
�STEP 1: Open the case and remove the card.
�STEP 2: Gently press down on the top opening tab on the red side.
�STEP 3: The USB connection should fold up. Flip open the tab with the red side down.
�STEP 4: Insert into the USB slot on the media player on the left side of MA/RMA series mixer amplifier.
�STEP 5: After a moment, the Pure Resonance Audio mixer amp should detect a signal from the USB and
switch to the USB input on the media player. You should see the play clock running.
�STEP 6: To adjust the volume on the media player, press and hold the vol + or vol - button. It may be
helpful to adjust the volume on the media player when blending masking with music.
�STEP 7: If desired, use the remote control to adjust the equalizer settings of the media player.
�STEP 8: Select the desired EQ setting of the media player and adjust the master volume and master EQ
settings as desired for your chosen blend of masking/music.
�STEP 9: After 10 hours, the masking will reach the end of the drive. It will then automatically repeat to
keep masking operating as continuously as possible.
PURE RESONANCE AUDIO®
[phone]
[e-mail]
www.PureResonanceAudio.com
Specifications may change without notice.
USB