PVI VECOAX MINIBLADE User manual

VECOAX MINIBLADE STEP BY STEP INSTALLATION GUIDE
NOTE: BEFORE INSTALLATION
Please test each MiniMod 2 unit UNMOUNTED ON A TEST BENCH with your Test TV
before installing your units to ensure you are receiving the Test Pattern signal. Then
Program your unit. If installing Multiple units, ensure each unit has its own frequency
it’s broadcasting on as well as Major/Minor Channel numbers.
To test, simply connect your TV with a short piece of Coax cable to the RF Out of the
Unit. Then, scan for channels on your test TV. No HDMI needs to be connected for
this test. This will display our test pattern on your TV once you scan for digital cable
channels. By default, our unit is set to QAM (J.83B Cable) mode.
Please refer to the unit’s Manual for programming instructions.

1.) Your MINIBLADE kit comes with MiniMod 2 units and accompanying MiniBlade
cover plates. (Fig 1.)
2.) On the side panel of the MiniMod with the RF In/Out, remove the 4 corner
screws shown. DO NOT remove the side plate. (Fig. 2)

3.) Place the cover plate over the RF In/Out connector side. (Fig. 3)
4.) Screw in the 4 spring screws to secure the cover plate to the unit. (Fig. 4)

5.) Screw the cover plate into your Rack Bars or Mount Adapters. 19” Rack Bars
pictured here. (Fig. 5, 6, 7)
6.) Repeat steps 1 through 5 for each MiniMod 2 unit. Then, install in your Rack
Mount and connect RF outputs to your distribution (Fig. 8)