Pyle SereneLife SLFCAB10 User manual

Security File Cabinets
Multi-Drawer Filing Cabinet with Combination Lock
Models: SLFCAB10, SLFCAB20
HOW TO SET A CUSTOM PASS CODE:
1. Adjust the pin to your current pass code (By default, the lock pin is set to “0000”).
2. Completely remove the top drawer from the cabinet and on the inside of the cabinet switch the
lever located on the lock from the B to A position.
3. While lever is in A position - set the desired new code. Make sure the 4 dials you set are exactly
parallel and lined up - you don’t want to set to the wrong number by mistake! (Sample below).
4. Once your new pass code is entered, change the lever back from A to the B position.
5. Make sure to write down & remember your code! There is no way to recover it once it is set!
by
0 0 0 0
1 3 1 4
A
B
A
B
A
B
A
B

SETUP:
1. Confirm the combination is set to “0000”and open the top drawer to separate the latch hook
from the lock (Open the bottom drawer and remove the pencil case, the labels and transparent label caps).
2. Hang the pencil case at the left or right groove of cabinet.
3. Fix all the labels and label caps to the corresponding grooves.
INTRODUCTION:
1. Your file cabinet comes equipped with a programable combination dial to securely lock the
drawers (By default, the lock pin is set to “0000”).
Please note: The special latch design of the cabinet prevents the bottom drawers from opening
unless the top drawer is pulled out. Even while pin is entered correctly the bottom drawers will be
locked until the top drawer is opened.
Security File Cabinets
Multi-Drawer Filing Cabinet with Combination Lock
Models: SLFCAB10, SLFCAB20
by