Pyle PCO850 User manual

PDUPowerStripSurgeProtector
PCO850
15Amp Power Supply Conditioner Rack-Mountable
Power Strip Surge Protector with 9 Outlets

www.PyleUSA.com
2
INTRODUCTION:
The PDU Power Strip Surge Protector has excellent surge protection feature for
all your systems，and they supply multiple outlets for your powering equipment.
It not only protects anything plugged into them from spike and surges, but also
has a built-in AC noise lter to rid the system of radio frequency and electromag-
netic interference. This allows all your equipments to function better and last
longer.
SAFETY INFORMATION:
TO OBTAIN BEST RESULTS FROM OUR POWER SUPPLY CONDITIONER UNIT,
PLEASE READ THE MANUAL CAREFULLY BEFORE USING.
WARINGS:
To reduce the risk of electrical shock, do not expose this equipment to rain or
moisture. Dangerous high voltage is present inside the enclosure.
Do not remove the covers. Refer servicing to qualied personnel only.
CAUTION:
These equipments shall be connected a 20 Ampere rated receptacle of the
branch circuit. The total current drawn from the receptacles of these equipments
is 15 Amperes maximum, and no individual receptacle shall draw more than 12
Ampere.
IMPORTANT SAFETY GUIDELINES:
Please pay close attention to the important operating and maintenance
instruction in this manual.
• Read the instructions.
• Keep and follow all the instructions. Heed all warnings.
• To prevent re or electric shock, do not expose this equipment to rain or
moisture. Do not use this apparatus near water.

www.PyleUSA.com
3
• Clean the unit with a damp cloth only. Do not use solvents or abrasive
cleaners. Never pour liquid on or into the unit.
• Do not install near any heat sources such as radiators, heat registers, stoves,
or other apparatuses ( including ampliers) that produce heat.
• Do not defeat the safety purpose of the polarized or grounding–type plug.
A polarized plug has two blades with one wider than the other. A grounding
plug has two blades and round grounding prong. The wide blade or third
prong is provided for your safety. If the provided plug does not t your outlet,
consult an electrician for the placement of the obsolete outlet.
• Route the power cord and other cables so that they are not likely to be
walked on, tripped over, or stressed. Pay particular attention to the condition
of the cords and cables at the plugs, and the point where the Power Supply
Conditioners. To prevent risk of re or injury, damaged cords and cables
should be replaced immediately.
• Unplug the unit during lightning storms or when unused for long periods of
time
• When wiring this unit and all other equipment used in connection to this unit
make sure that all of your equipment is turned OFF.
• Once installation and wiring is complete power on all your equipment with
the volume and level controls DOWN. Once all the equipment is ON slowly
raise the volume or level controls to their proper positions.
• Before placing, installing, rigging, or suspending any product, inspect all
hardware, suspension, cabinets, brackets, and associated equipment of
damage. Any missing corroded, deformed, or non- load rated component
could signicantly reduce the strength of the installation, placement or array.

www.PyleUSA.com
4
Any such condition severely reduces the safety of the installation and should
be immediately corrected. Use only hardware which is rated for the loading
condition of the installation and any possible short- term, unexpected over-
loading. Never exceed the rating of the hardware or equipment.
• Consult a licensed, professional engineer regarding physical equipment
installation. Ensure that all local state and national regulations regarding the
safety and operation of equipment are understood and adhered to.
• Refer all servicing to qualied service personnel. Servicing is required when
the apparatus has been damaged in any way. Such as power supply cord or
plug is damaged, liquid has been spilled or objects have fallen into the
apparatus, the apparatus has been exposed to rain or moisture, does not
operate normally, or has been dropped.
FRONT & BACK PANEL FEATURES:

www.PyleUSA.com
5
FEATURES:
• Safely Provides Surge Protection Control
• 9 Total Outlets (8) Rear and (1) Front
• Built-in AC Noise Filter
• 15 Amp Rating with Circuit Breaker
• Eliminates Unwanted Radio Frequency Interference (RFI)
and Electromagnetic Interference (EMI)
• Spike and Surge Protection
• 1U Rack Mountable
• Aluminum Front Panel and Steel Chassis
• Push to Reset
WHAT’S IN THE BOX:
• PDU Power Strip Surge Protector
TECHNICAL SPECS:
• Power Supply: 120V/50Hz, UL Standard Socket
• Construction Material: Iron
• 6 Foot Power Cord (3x14 AWG)
• Energy Dissipation: 150 Joules
• Peak Impulse Current: 1200 Amps
• Operating Voltage: 120V - 60Hz
• Dimensions (L x D x H): 19.0 x 3.9 x 1.8 inches

Questions? Issues?
We are here to help!
Phone: [phone]
Email: suppor[email protected]