Q&Q D056-500Y User manual

D056-500Y
Instruction for LED Alarm Clock
1. Alarm Indicator
2. Alarm set button
3. Time set buton
4. Minute set button
5. snooze button
6. Hour set button
7. Alarm ON/OFF switch
8. Alarm HI/LOW switch
To Operate Clock
Blinking display/PM Indicator/ Alarm On Indicator
When the clock is plugged in, the display will blink on and off meaning the
incorrect time is being displayed. You should always check the time when
this is indicated. When the alarm indicator is on, the alarm will sound at
the time set.
Set Time
Press the Time button and the Hour button until the correct hour is
displayed, then release the Hour and press the Minute button until the
correct minute is displayed.
Set Alarm
Press and hold the Alarm button and the Hour or Minute button as above.
To Operate Alarm
Slide the Alarm ON/OFF switch to ON position. The alarm will sound at he
time set. To shut off the alarm, slide the Alarm ON/OFF switch to OFF
position. Slide the Alarm HI/LOW switch to HI for loud alarm or LOW for
normal alarm.
Snooze
Press case top to activate snooze and get extra 8-9minutes of sleep.
Battery Back up
Insert one 9V battery into the battery compartment on the back-side of
the clock. The battery will hold the ALARM and the Time settings until
power is restored. If there is no battery and the power is interrupted, the
display will flash and the ALARM and the TIME will need to be reset.

Maintenance
A soft cloth or a paper towel may be used to clean your clock. Do not use
any corrosive cleanser or chemical solutions on the clock. Keep the clock
clean and dry to avoid any problems.
Safety Instructions
The apparatus shall not be exposed to dripping or splashing. No objects
filled with liquids, such as vases, shall be placed on the apparatus.
Ventilation- The appliance should be situated so that its location or
position does not interfere with its proper ventilation. For example, the
appliance should not be placed on a bed, sofa, rug or similar surface that
may block the ventilation opening; or placed in a built-in installation, such
as bookcase or cabinet that may impede the flow of air through the
ventilation openings. The appliance should be situation away from heat
sources such as radiators, heat registers, stoves or other appliance
(including amplifiers ) that produce heat. Power-cord protection – Power
supply cords should be routed so that they are not likely to be walked on
or pinched by items placed upon or against them, paying particular
attention to cords at plugs, convenience receptacles, and the point where
they exit from the appliance.
Disconnect from mains when not in use.
To avoid the risk of electric shock, do not remove the cover of the
apparatus. There are no user serviceable parts inside. Do not operate this
product if the mains lead is damaged. The mains lead must be replaced fy
the manufacturer or its appointed agent,
Please read the instruction manual before use and retain for future
reference.
The rating label is on the unit’s bottom.
During electro static discharge, the product may auto reset then adjust
the mode to return normal operation.