QTX Light QTFX-700 User manual
12
1
QTFX-700
Smoke Machine User Manual
160.452UK
User Manual – QTFX-700 160.452UK
2
QTFX-700 Smoke Machine – For indoor use only
1. General Introduction :
A small, stylish 700W smoke machine with a high quality heater block and
pump. The unit can produce smoke quickly due to the low reheat time and
includes a wired remote control. This is an ideal product for mobile D s and
travelling bands that require a cost effective and reliable solution when
performing.
Features :
High performance heating element
7000 Cu Ft (198m³) per minute
Stylish metal housing
Removable tank for easy maintenance
Small, robust and lightweight housing
Supplied with remote control
Caution! Please read this manual carefully before
operating! Damage caused by misuse
is not covered by the arranty!
11
User Manual – QTFX-700 160.452UK
10
12. Technical specification :
Po er supply 230Vac, 50Hz
Fuse F5A
Po er 700W
Re-heat time 4 min (approx)
Smoke Output 7000 Cu Ft (198m³) / min
Tank capacity 0.8 Litres
Dimensions 210 x 220 x 335mm
Weight 3.3kg
13. Disposal :
Please disposal of the unserviceable device according to the current
statutory requirements.
User Manual – QTFX-700 160.452UK
3
2. Package Contents :
Please check the contents to ensure that the product has been received in
good condition.
QTFX-700W Smoke Machine x 1pcs User’s Guide x 1pcs
Power Cord x 1pcs Remote control x 1pcs
If you find any accessory is missing or the machine has arrived with any
problems, please contact your local dealer at once. Do not try to fix this
item yourself or you will lose the warranty. Please keep the original package
and invoice for any possible replacement or returned demand.
3. Recommended Fluid:
For the QTFX700 smoke machine we strongly recommend the following
fluids which have been specifically formulated to perform best in any
smoke machines with a power rating up to 900W
QTX Ref Code Description Size Results
160.643UK 1 Litre
160.582UK
Standard grade smoke
fluid 5 Litre
High quality
smoke
160.587UK 1 Litre
160.588UK
High grade smoke fluid
5 Litre
Long lasting
high quality
smoke
User Manual – QTFX-700 160.452UK
4
4. Setup :
1. Unpack the fog machine
2. Unscrew the top cap of the tank and remove to fill with the
recommended smoke fluid
3. Replace the bottle and screw the cap securely ensuring the pipe is
fed down to the bottom of the bottle so a consistent flow of fluid is
supplied to the machine
4. Connect the remote control
5. Connect the IEC mains plug and power up
6. Heat up time is usually between 3-6 minutes. Please ensure no
button is pressed during the heat up time. When the machine is
ready the LED light on the remote control will illuminate
7. Press the button on the remote control for 5 seconds so the fluid has
a chance to flow through the heater block making it ready to use..
8. After this you will be able to use the smoke machine. It is
recommended to produce smoke with small pauses in between so
that the temperature is maintained and the thermostat doesn’t
switch off.
User Manual – QTFX-700 160.452UK
9
1) IEC Power socket
2) Fuse holder
3) Remote control socket
4) Fluid tank
5) Fixation screw
6) Fluid level
User Manual – QTFX-700 160.452UK
8
11. Rear Layout:
User Manual – QTFX-700 160.452UK
5
5. Mounting instruction :
The fixture may be mounted in any position provided there is adequate
room for ventilation and the fluid can not leak.
It is important never to obstruct the front of the machine, fan or vents
pathway. Mount the fixture using a clamp.
Adjust angle of the fixture loosening both knobs and tilting the fixture.
After finding desired position, re-tighten both knobs.
When selecting installation location, take into consideration refilling the
tank and routine maintenance. Safety cables must always be used.
Never mount in places where the fixture will be exposed to rain, high
humidity, extreme temperatures changes or restricted ventilation.
6. Caution! To prevent Mortal Electrical Risk and Long Life Operation :
For your safety, please kindly pay attention to all of the warnings listed
below:
Always plug in the power plug last and disconnect from the mains
when the device is not in use or before cleaning.
Do not install and operate the device in rain or extreme heat,
moisture or dusty environments.
This device is for indoor use only and in a dry environment.
Do not switch on immediately but wait until it reaches to room
temperature if the device has been exposed to drastic temperature
fluctuations.
Do not shake the device and avoid brute force when installing or
operating
Do not use the device during thunderstorms and please disconnect
the power.
User Manual – QTFX-700 160.452UK
6
Do not use solvents or aggressive detergent to clean the device. Use
a soft and clean cloth.
Do not modify the device or the connected power cord without
authorization.
Use appropriate safety-rope for safety.
Clean the machine regularly using water or smoke cleaning fluid
(160.670)
7. Connect ith po er supply - The ground ire must be connected :
Use the plug to connect to the main power supply as following.
Wire Connection International signal
Brown Live L
Blue Neutral N
Yellow /Green Earth
8. Quick Trouble Shooting :
If the unit is not functioning properly
8.1 Check if main power is on and fuse hasn’t blown
8.2 The remote control is plugged in correctly in to the socket
8.3 Check there is fluid in the tank
8.4 Check that the pipe is pushed down to the bottom of the tank
8.5 Check the correct fluid has been used.
8.6 If there is a block use distilled water or smoke machine cleaning fluid.
User Manual – QTFX-700 160.452UK
7
9. Replacing Fuse :
Disconnect from the main power supply first, then remove the fuse holder
above the IEC Socket to reveal the fuse. Replace the correct fuse rating as
stated on lighting or user guide. Then, lock the fuse holder cover back into
place.
10. General Maintenance :
To maintain optimum performance and minimize wear, the item should be
cleaned frequently. Usage and environment are contributing factors in
determining frequency. As a general rule, fixtures should be cleaned after
use to avoid dust build-up and blockages, which can result in poor
performances, overheating and breakages. Be sure to power off fixture
before conducting maintenance.
Unplug fixture from power. Use a vacuum or air compressor and a soft
brush to remove dust collected on external vents and internal components.
Clean the external case when the fixture is cold with a dry cloth or tissue,
and drag dirt and grime to the outside case.
To ensure a continuing high performance it is recommended to use water
or smoke cleaning fluid (160.670) to clean the internal workings. Simply
empty the tank of any smoke fluid. Fill with water or smoke cleaning fluid
then operate two full cycles to clean the internal pipes this should be done
once every 2 months to ensure continuing high performance
Other QTX Light Fog Machine manuals
