Quick-Sling QSLG1000 User manual

391 West Water St.
Taunton, MA 02780
1-800-699-0453
www.Quick-Sling.com
Quick Sling Hanger Unit Installation: (Please adhere to all local laws and building codes)
Model#: (QSLG1000)
Step #1:Remove pre-assembled J-
Bars & Extension Arms from box and
lay on a flat surface.
Step #2:Remove 30.5” Extension Bar
& insert into bottom of two J-Bars
(2 x’s).
Step #3:Determine desired width, then
insert & tighten ¼“-20 Thumb Screws
(Green Labeled Bag). Make sure
centerline mark on SL103 is equal
distance from each J-Bar.
Step #4:Adjust L & R Hanger Arms
(SL101) to desired height. You may
also adjust height after installation to
provide a level surface for the HVAC
Unit. See Photo #1 & #3 for reference.
Step #5: Hang the Quick Sling Unit
using hardware in Purple & Orange
Labeled Bags. One Through Bolt & two
Pan Head screws must go in each
Hanger Arm. See Photo #1.
Step #6: After the Sling Unit is hanging,
attach the two 2-piece Spacer Bar &
Saddle connecting both frames (SL104
& SL105) and tighten the thumbscrews.
Step #7: Now hang (SL106) Drain Pan
Support on each J-Bar Frame (See
Photo #2). You are now ready to insert
HVAC Unit & Secondary Drain Pan.
Step #8: Use Anti-Vibration Rubber
Pads (Pink Labeled Bag) between
HVAC unit and J-Bar Frame.
Photo #1
(On left)
Extension
Arms
mounted to
Rafters with
enclosed
hardware.
Photo #2
(On left)
Drain Pan
Hanger
Support &
Drain Pan
on bottom
of Sling.
Photo #3
(On left)
Quick Sling
Hanger Unit
installed on
Rafters with
Furnace &
Drain Pan.
Please see important “Safe Install” information on back page.
!
SL101
SL103
SL106
SL104
SL105
SL102

Safe Install Warning
Install At Your Own Risk!
The load capacity of this product can only be assured if installation is carried out properly.
Mounting hardware is included with most models. However, it is the Buyer’s sole
responsibility to determine that the enclosed hardware is safe and suitable for the selected
mounting location. Additional materials and safety precautions may be required, depending
upon the size and location of the installation. When hardware is not included, the Buyer is
solely responsible for furnishing and installing anchors and related mounting materials that
are safe and suitable for the selected mounting location. Quick-Sling™ is not responsible
for any installation faults or defects. It is highly recommended that the installation/mounting
location be periodically inspected by a skilled technician. Make sure that the installation
location is suitable enough to hold the brackets and associated equipment loads.
Disclaimer Of Liability
Quick-Sling LLC and its successors, distributors, jobbers, dealers and retailers (“Seller”)
shall in no way be responsible for any direct, indirect or consequential damage resulting from
improper installation, misuse or misapplication of this product. It is the BUYER’s sole
responsibility for assuring proper installation and use.
Seller makes no warranty of merchantibility of the goods or the
fitness of the goods for any particular purpose. Seller makes no
warranties of any kind, express or implied. The goods are sold as-
is and with all faults.