QuickLink Studio-in-a-box User manual

Fitting a PTZ camera
into the Studio-in-a-box
Instructions
Rev 2

quicklink.tv
1
Remove the 6 screws on the rear panel using a Torx Tamperproof
T10H S2 screwdriver head. Then remove the panel.
Unplug the 4-pin fan connector.
1
2

quicklink.tv
2
Take the camera mounting plate included with the camera. Screw
the mounting plate onto the housing roof of the Studio-in-a-box
using the 4 screws (Provided by Quicklink) with a 2.5mm Hexagon
Bit screwdriver head.
IMPORTANT: When completing this step, please ensure that the four screws provided by
Quicklink are used. Failure to do so may result in permanent damage to the motherboard.
Lift the PTZ camera onto the camera mounting plate inside the
Studio-in-a-box, aligning the holes on the camera to the mounting
plate and then rotating the camera roughly 15 degrees.
3
4

quicklink.tv
3
Screw the camera to the mounting plate to lock the camera in place.
Connect the HDMI cable to the camera.
5
6

quicklink.tv
4
Connect the Ethernet cable into the RJ45 socket.
Connect the 12v red/black power cable to the camera.
7
8

quicklink.tv
5
Secure the cables together using the cable clamp.
Re-connect the 4-pin fan connector.
9
10

quicklink.tv
6
Place the back panel onto the Studio-in-a-box, screwing in the 6
screws with a Torx Tamperproof T10H S2 screwdriver head.
Configuring the camera
To finish setting up the camera, please contact the Quicklink Support team who will complete configuration.
How to contact Quicklink Support
►Email: [e-mail]
►Telephone: [phone] (ext 2)
11