R. Schütt Simplex 400 User manual

Operation manual Simplex 400/450
Simplex 400
Simplex 450
Page 01
January 2019

The copyright to these Operating and Installations is held by
R. Schütt GmbH.
These instructions are intended for the operating, installation, maintenance
and supervisory personnel.
They may not be partially or wholly copied, distributed or for competitive
purposes turned to account without authorization or communicated to third
parties.
Copyright
Producer:
R. Schütt GmbH Tel.: [phone]
An den Hässeln 14 Fax: [phone]
57462 Olpe-Oberveischede E-mail: [email protected]
Internet : www.rschuett.de
Contents list
1. Cover sheet Simplex 400/450 Page 1
2. Contents list, copy right and complete address Page 2
3. Technical datas Page 3
4. Versions and handling Page 4
5. Seals and maintenance Page 5
6. Maintenance Page 6
Page 02

Sampler: Version with handwheel
Sealings: PTFE-seal cone, O-ring silicon (FDA compliant)
Material: AISI 316 L product contact; AISI 304 no product contact
Pipe pressure: from 0 - 12 bar (0-175psi)
Opening way: approx 5 mm
Flow diameter: Ø 10 mm
Versions: different in- and output sizes your specification
Maintenance time: max. 5 sealing, time to change approx 3-5 minutes
Different
input
connections
Cleaning connection
Simplex 400
Simplex 450
Technical datas
Different output
connections
Page 03
Different
input
connections
Different output
connections

Versions
Cleaning input and sampler output,
in different
versions and sizes.
e.g.: 1/2“; 5/8“;
straight or 45°
In addition to hose nozzles,
in different sizes,
also cooling coil
can be connected.
Handling
CIP cleaning completely cleans the Simplex 400 and 450.
The Simplex 450 has the advantage that it can be cleaned and sterilized through the cleaning input
before sampling.
After each sample the Simplex 450 should be cleaned, then close the output and fill the sampler with
alcohol through the cleaning input, then close the cleaning input. Until the next sample the sampler
stays inside sterile.
Page 04

Seals and maintenance
AE00.0330 retaining ring
AE00.0332 O-ring
A00.0334 PTFE-seal cone
AE00.0318a flat seal1/2“
AE01.0232 o-ring 27x2
Maintenance
1. Step
Release locking screw
with Phillips screwdriver
3. Step
Remove retaining ring
2.Step
Remove handwheel cap
4. Stepp
Remove outer O-ring
Page 05

Maintenance
5. Step
Unscrew the spindle with the
handwheel cap
6. Step
Tapping the Teflon seal
cone off the spindle with a
flat-head screwdriver
After replacing the seals, reassemble the sampler in reverse order. To more easily press the Teflon seal
cone onto the spindle, it should be heated to 50-70° C (eg in warm water).
7. Step
Remove O-ring
Page 06
Important NOTE!
If the sampler is used with weld-on sockets,
all seals must be removed before welding.
Procedure see Maintenance.